BestPartner Parabola XP User manual

BestPartner Parabola XP antennas installation maunal.
Applies to Parabola XP 2.4 GHz and 5.x GHz antennas.
Procedure:
1. Attach the antenna to the pole using included
handle.
2. Attach 2 u-bolts b inserting them through
saddle clamps and securing with nuts and lock
washers.
3. Place antenna over pole, align horizontal
direction b rotating on pole and tighten the u-bolt
nuts.
4. Set up vertical align using included handle with
graduation. Tighten the nuts in desired handle
position.
5. Attach a low loss signal cable to the integrated
N(F) connector. Seal the connector joint with
waterproof sealing tape or sealing compoud.
Note 1:
The mounting handle is suitable fore pole diameters
from ½ to 1 ¾ inches. Mountning poles and their
supports should be designed to withstand the wind
loads as required b the local building code.
Note 2:
To set the bending of the antenna, use the α and β
graduation. See the table and pictures below.
Tab.1: Central beam range (in meteres):
Antenna
Altitude /
Lean 1° 2° 3° 4° 5° 6° 7° 8° 9° 10° 11° 12° 13° 14° 15°
20 m 1146 573 382 286 229 190 163 142 126 113 103 94 87 80 75
50 m 2864 1432 954 715 572 476 407 356 316 284 257 235 217 201 187
75 m 4297 2148 1431 1073 857 714 611 534 474 425 386 353 325 301 280
100 m 5729 2864 1908 1430 1143 951 814 712 631 567 514 470 433 401 373

Examples of setting the β graduation:
Vertical:
Bend down:
Bend up:
Example of setting β and α auxiliar graduation (to bend the antenna even more):

Polarization examples:
Horizontal polarization:
Vertical polarization: