Bestway 32096 User manual

©2022 Bestway Inflatables & Material Corp.
All rights reserved/Tous droits réservés/Todos los derechos reservados/Alle Rechte vorbehalten/Tutti i diritti riservati
Trademarks used in some countries under license from/
Marques utilisées dans certains pays sous la licence de/
Marcas comerciales utilizadas en algunos países bajo la licencia de/
Die Warenzeichen werden in einigen Ländern verwendet unter Lizenz der/
Marchi utilizzati in alcuni paesi concessi in licenza a
Bestway Inflatables & Material Corp., Shanghai, China
Manufactured, distributed and represented in the European Union by/
Fabriqués, distribués et représentés dans l’Union Européenne par/Fabricado, distribuido y representado en la Unión Europea por/
Hergestellt, vertrieben und in der Europäischen Union vertreten von/Prodotto, distribuito e rappresentato nell'Unione Europea da
Bestway Europe S.p.a., Via Resistenza, 5, 20098 San Giuliano Milanese (Milano), Italy
Distributed in Latin America by/Distribué en Amérique latine par/Distribuido en Latinoamérica por/Distribuído na América Latina por
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea, Pudahuel, Santiago, Chile
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia
Tel: Australia: ([phone]; New Zealand: 0800 142 101
Distributed in United Kingdom by Bestway Corp UK Ltd. 8 Wentworth Road, Heathfield Industrial Estate, Newton Abbot, Devon, TQ12 6TL
Exported by/Exporté par/Exportado por/Exportiert von/Esportato da
Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited
Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon, Hong Kong
www.bestwaycorp.com

WARNING
THE SUPERVISOR SHOULD BE WITHIN
ARM’S REACH OF THE WEARER.
INFLATE AND FIT
1. Open the safety valve, squeeze the valve at
the base and inflate the air chamber by steps
with an air pump (Pump is not included). Fill
the chambers until most of the wrinkles are
gone and it feels firm to touch but NOT hard.
Close the valve firmly when finished. Press
the valve downward into the air chamber, so
that it does not get over the surface.
Note: Never over-inflate or use compressed
air to inflate.
2. With the swim seat facing up, position the
child’s legs through the bottom leg holes of
the swim seat. Child’s body should be
approximately upright. Be sure the swim seat
fits around the child’s lower body securely,
and the water level is at or about the level of
the NIPPLE. Place the swim seat at first into
water, out of the child’s standing depth and
then put the child into the swim seat.
3. Warning: Do not bite or chew the product as
pieces that may be bitten off from the material
may cause a choking hazard.
USER MANUAL FOR SWIM SEAT
4. The use of diapers or any other apparel or
device shall not lead to an entrapment of the
child inside the seat.
DEFLATE AND REMOVE
1. In sufficiently deep water take the baby off the
swim seat first.
2. Pull out the safety valve, pinching the valve to
release the air.
MAINTENANCE AND STORAGE
1. Rinse with water and air dry thoroughly
before storing it. Place it in a dry place,
normal room condition, out of direct sun light
and the deflated swim seat should not be
compressed by other weights on it.
2. Check seams and foil regularly for tears and
holes. If there is any defect, please discard
the products and replace by a new one.
NOTE: With proper maintenance and storage,
the product life span is 4 years from the date of
manufacture. You should thereupon accordingly
replace the product.
11 kg
15 kg – 19 kg
30 kg – 60 kg
11 kg – 15 kg
19 kg – 30 kg
> 60 kg
~ 12 months
~ 24 months to 36 months
~ 6 years to 12 years
~ 12 months to 24 months
~ 3 years to 6 years
~ over 12 years
Guidance – Approximate body weight: age group
≤ 11 11 - 15 15 - 19 19 - 30 30 - 60 ≥ 60
√
... _ ... kg
303021301532
2