BFG Technologies Grower Select Ultra Plastic Bench Top User manual

Ultra Plastic Bench Top
Aembly Manual
bench top only – legs and roing systems available but sold separately

2800-883-0234
ULTRA PLASTIC BENCH TOP
Ultra Plastic Bench Top Aembly Manual
Thank you for your order, this assembly manual was created to provide you the information
and required steps needed when assembling your new Grower Select Bench System. Please
check the packing slip when the order is received. Separate out all the parts and count them to
ensure everything needed is included. If there are questions about the shipment, or assembly
steps please call BFG Supply at 1-800-798-2891.
• Hammer
• Drill with Assorted Bits (Impact Driver Recommended)
• 5/16in Hex Head Driver, Assorted Other Drivers, 7/16in Driver/Socket
• Hack Saw
• Flat Head/Philips Screw Drivers
• Leather Gloves
Aluminum Rail Bench Top Ends
and Sides Trim
Bench Top Crossbar Support
(Hat Section), Standard Spacing
is 2ft On Center
Ultra Plastic Bench Top Sections
Ultra Plastic Bench Top Clips ¾in Tek Screws to be used to:
Attach Aluminum Rails and
Bench Top Crossbar Supports
(Hat Sections), Aluminum Rails
in Corners and Corner Protectors
Corner Protectors
Tls Nded
Pas Descption List

3
www.bfgsupply.com
ULTRA PLASTIC BENCH TOP
Ultra Plastic Bench Top Aembly Manual
NOTE: Please read through the instructions completely before starting!
WARNING: The hat sections as well as the other steel pieces can have very sharp edges.
Take precautions when handling. Wear Gloves!
Take the Bench Top Crossbar
Supports (Hat Sections) and
place them at 2ft on center.
Take the 2 pieces of Aluminum Rail Bench Top Side Trim and slide the Bench Top Crossbar Supports
(Hat Sections) into them. Repeat this step with the other piece of Side Trim. Using a ¾in TEK Screw
from underneath, anchor each end of the Hat Sections to the Aluminum Rail. If splicing is required on
Aluminum Side Rails, splices should not be directly opposite each other. Each end of the splice should
be attached to a Hat Section as in the pictures below.
Step 1 of 6
Step 2 of 6

4800-883-0234
ULTRA PLASTIC BENCH TOP
Ultra Plastic Bench Top Aembly Manual
The end Hat Sections should
be positioned half on, half o
the aluminum end rail as in
the picture to the right. Take
the 2 pieces of Aluminum Rail
Bench Top End Trim and t them
together with the Side Trim.
Then attach the 4 corners of the
trim with 3/4in TEK Screws.
Take the sections of Ultra Plastic Bench Top and place them on top of the Hat Sections and Trim and
attach them to one another using the clip in the picture below.
Put the Ultra Plastic Tops and Hat Sections together with the Aluminum Rail as shown in the picture
below.
Step 3 of 6
Step 4 of 6

5
www.bfgsupply.com
ULTRA PLASTIC BENCH TOP
Ultra Plastic Bench Top Aembly Manual
Take the 4 Corner Protectors and attach
them to the 4 corners of the Aluminum Rails
using a ¾in TEK Screw on each side.
ALL DONE. The Bench Top should look like
the picture to the right. If there are any
questions about any of the above steps
please call BFG Supply at 1-800-798-2891.
Step 5 of 6
Step 6 of 6