BIG FURNITURE WAREHOUSE Global Verona OTTVERCHA User manual

1
Do not discard any of the packaging until you have checked the product.
Outlined below are General Care Instructions that will help prolong the look and life of your ooman
by preventing wear and damage.
PLEASE NOTE: The Fabric on this product is Flame Retardant
treated and therefore should be Specialist Upholstery cleaned only
CLEAN REGULARLY:
Remove dust by pre-brushing with a ooman brush
Gently Vacuumall areas
SUNLIGHT AND HEAT
Direct sunlight or heat can cause fabrics to deteriorate or fade. Protect themby situating your
furniture out of the way of prolonged direct sunlight or by drawing curtains and blinds when
applicable.
Avoid placing furniture too close to fires or radiators.
Reduce potential damage by moving items around or changing position so that the same piece
or area is not always exposed.
SAFETY WARNINGS
ENTRAPMENT WARNING:
KEEP HANDS CLEAR WHEN
ADJUSTING THE RATCHET MECHANISM TO AVOID
FINGER ENTRAPMENT: DO NOT ALLOW CHILDREN TO
ADJUST THE MECHANSIM.
Never allow children to jump on the Ooman .
Do not allow domestic pets to climb on the ooman or
chew or claw it; oils and greases fromanimals will
cause deterioration in the appearance of the fabric.
Sharp objects such as buckles, toys and jewellery can
easily snag on the fabric and produce tears and pulls in
the fabric.
Hot objects such as the heat fromcups and mugs can
permanently disfigure upholstery.
ASSEMBLY INSTRUCTION OF STORAGE OTTOMAN
Global

2
Parts List:
A
B
1
3
2
Plasc spacer x 4pcs
Plasc KD wood x 4pcs
Metallic conduit x 4pcs
Gas strut hinge x 1pc
E
F
Metal hinge x 3pcs
Screw-1 x 23pcx
Screw-2 x 16pcx
C
D
G
1) Posion the iron pipe in the direcon shown in the picture, and screw the armrest
and back plate respecvely.
2) In accordance with the requirements of the step 1, fix four corners well.
3) Put the hinge on the back plate, and screw 3 parts.

4
5
6A
3
4) Holding the top to match the posion of the hinges, screw and fix top and back plate.
5) Screw the round base of gas strut hinge on the right armrest, press the gas strut hinge
into, screw the other side on the top.
6) Place the leg with plasc chip as picture, and screw 4 legs