BIG GOOSE BG-101 User manual

Push down on the unit to adjust the depth to the
bottom of the pan (Fig.2). Fits pans up to 3” deep.
Finish tightening thumb screw.
5.
6.
Fig. 1
Thumb Screw
SECONDARY PAN SENSOR
FOR METAL & PLASTIC PANS
INSTALL FLOAT SWITCH ON DRAIN PAN
(To ensure proper performance of product,
instructions must be followed.)
Disconnect power to unit at main panel.
Disconnect power to the low voltage thermostat
circuit.
Slide the float switch onto the side of the pan.
Lightly secure the float switch by tightening the
thumb screws (Fig.1). Do not over tighten.
1.
2.
3.
4.
WARNING: WORK SAFE, READ THIS!
FAILURE TO READ AND COMPLY WITH ALL WARNINGS,
CAUTIONS, INSTRUCTIONS PRIOR TO STARTING
INSTALLATION MAY CAUSE PERSONAL INJURY AND/OR
PROPERTY DAMAGE AND VOID WARRANTY.
This device must be installed in accordance with
manufacturer’s instructions. This installation must
be in accordance with all applicable local plumbing,
drainage, and electrical codes.
This device must be installed in accordance with
manufacturer’s instructions. This installation must
be in accordance with all applicable local plumbing,
drainage, and electrical codes.
Remove electric shock hazard — DISCONNECT
THE POWER BEFORE INSTALLING SWITCH to avoid
electrical shock and/or equipment damage. Do not
use on circuits exceeding 24 volts to avoid damage
to switch, shock, or fire hazard. Switch must be
connected to an isolated transformer with a max
rating of 30VAC, 8A, and 100VA.
In any installation where property damage might
result from inoperative switch due to a power outage,
back-up system(s) and/or alarm should be installed.
The switch must only be installed by a licensed
contractor or under the direct supervision of same.
The condensation pan must be properly maintained
after installation and remain free from foreign
objects, rust, or other obstructions that might
interfere with the proper operation of the float switch.
INSTRUCTIONS

Check that the float is in the lower position.
If it is not, lower the float using your finger, as
shown on (Fig. 4).
At start up, check initial average load.
With unit on, test switch by raising float as
shown. Unit should stop running if switch is
correctly wired.
To test switch responsiveness, fill pan with
water to ensure that the switch stops the unit
before the pan overflows; once confirmed,
remove the water.
a.
b.
c.
d.
TEST THE FLOAT SWITCH
4.
WIRING THE BG-101 IN A
CONVENTIONAL HVAC SYSTEM
(To ensure proper performance of product,
instructions must be followed.)
Ensure the power is disconnected to the unit at
the main panel prior to moving to the next step.
Refer to the appliance manufacturer’s installation
and operating instructions and also review wire
layout in their instructions.
Locate the Red wire coming from the 24 volt
thermostat “R” terminal.
NOTE: If not present, it is recommended that an
inline fuse to protect 24-volt circuit be installed.
Disconnect or cut red wire. Connect one of the
long wires of the BG-101, using a wire nut, to the
thermostat side of the circuit. Connect the other
long wire of the BG-101, using a wire nut, to the air
handler side of the circuit or to the terminal in the
unit. Incorporating both switch wires in the red
circuit will shut the unit off (fig.3)
INSTRUCCIONES ESPANOL
Visite en línea para obtener instrucciones en español
BigGoose.com/instructions/
For warranty information, please go to
www.biggoose.com
UL 508 APPROVED
40-001007
REV S
Fig. 3
Fig. 2
Typically Red
Normally Closed
Normally Closed
Fig. 4
1.
2.
3.
24 volts AC, 4 Amps
US Patents Pending