Biktrix SW900 User manual

SW900 Display Manual
Biktrix Version
LCD DisplayDetails
Control Pad Description
DisplayOperations
Powering On/Off the Display
Press and hold the MENU button to power on the display. When the display is turned on
press and hold the MENU button to turn the display off.
Changing Assist Levels
Press the UP button to increase the PAS level. Press the DOWN button to decrease the
PAS level.
Operating the Headlight
Press the red HEADLIGHT button located on the right handlebar to turn on and off the
headlight.
Entering Walking Mode
When the bike is stationary press and hold the DOWN button. This will enter it into
walking mode where the motor will propel the bike at a speed of 6 km/h for you to walk
alongside it. To exit this mode, release the DOWN button.

Switching Readings on the MultifunctionDisplay
Press the MENU button to change information shown on the Multi Function display.
These will change in the order of: Total Distance (ODO) → Single Trip Distance (TRIP).
Switching readings on the Speed Display
Hold the MENU and UP buttons to switch displayed readings on the Speed display
area. This will switch between Current Speed, Average Speed and Max Speed in that
order.
Entering the Display Settings Interface
To enter the settings interface press and hold the UP and DOWN buttons
simultaneously. With a parameter selected use the UP and DOWN buttons to add or
subtract fromthat value; this is how you change it. Short press the MENU button to
save your changes and advance to the next parameter. Exit the Settings Interfaceand
save all changed parametersat any time by holding the UP and DOWN buttons
simultaneously.
Display Setting Interface Options
•P01: Backlight Brightness
o1 is the darkest, 3 is the brightest.
•P02: Mileage Unit
o0 for KM/metric,1 for Miles/Imperial.
•P03: Voltage Class DO NOT CHANGE
•P04: Display Auto-off Time in minutes
oSet to 0 to have display only turn off manually.
•P05: PAS Grades
o0 for 3 PAS Levels (0-3)
o1 for 5 PAS Levels (0-5)
o2 for 9 PAS Levels (0-9)
•P06: Wheel diameter
oThis only needs to be changed if you put different sized wheels on the
bike. Unit is inches.
•P07: Speed Sensor Signal DO NOT CHANGE
•P08: Speed Limit
oSets the max speed limit for the bike. Value can be set between 0-41 km/h
with 41 being the max value where there will be no speed limit.
•P16: Odometer Reset
oPress and hold the UP button for 5 seconds to reset TRIP odometer.
•P18: Unused - DO NOT CHANGE