Kit Includes: 1 x table top, 1 x base, 4x linear 50mm round post, 4x adjustable feet, 6x wing extrusion
Screw the stand-off’s down onto
the stand-off locators until fully
secure. Repeat this for the
remaining stand-off’s
Place the pre-drilled holes of the top
shelf over the stand-off until in
required position
Screw down the top of the stand-
off over the top shelf until fully
secure, repeat these steps for the
rest of the stand-off’s
Top shelf assembly (pro unit only)
Start by placing the top of the
counter face down with the twist
and lock locators facing up. Place
the posts into the twist and lock
locators and twist anti-clockwise to
lock and clockwise to unlock
Place the base of the counter over
the linear post and place the
adjustable feet through the washer
and into the base of the counter.
Screw into the post until in
required position. Hand tighten the
nut to secure into place.
To attach the graphic simply click
the PVC wing extrusion into the
channel in the 50mm round post.
Repeat this step for the remaining
graphics
To attach the internal shelf insert
the twist and lock pole into the
locator on the shelf
Lift the internal shelf to the shelf
locators on the base side of the
table top. Twist each pole into place
until fully secure
Optional Internal shelf assembly
Call: 01767 603 930 | www.parkesexpo.com | e: sales@parkesexpo.com
Parkes Display & Expo | 41 Hitchin Street | Biggleswade | Beds | SG18 8BE | 01767 603930
1
1
1
2
2
2
3
3
Assembly Instructions
