Binatone SH057 User manual

Bluetooth headphone
SH057
❶Pairing:
1. Hold MFB for 4 seconds
2. Select "Escape 220" from the smartphone Bluetooth menu.
❷Basic Operation:
Volume +
Volume -
MFB
❸Charging
Fully charge before use
The device can be powered through a micro USB from any CE compliant power source that
implement the European interface as requested by EN 301 489-52.
Additional Operation
Power On
Hold MFB for 2 seconds from OFF status
Force Pairing
Hold MFB for 4 seconds from OFF status
Power Off
Hold MFB for 2 seconds from ON status
Receive incoming call and on-hold ongoing call
Single Press MFB
Receive second incoming call and end ongoing call
Triple Press MFB
Reject a call
Hold Vol- for 2 seconds
Voice Command (Siri/Google/Alexa)
Double Press MFB (Only available in standby
mode)
LED Indicator
Pairing
Red-blue flash
Standby
Blue flash
Charging
Red steady
Full charged
Blue steady
Battery low
Red flash

FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
ϋϋ Reorient or relocate the receiving antenna.
ϋϋ Increase the separation between the equipment and receiver.
ϋϋConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
ϋϋ Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.