Bircher XRF-TI Instruction manual
1
XRF-TI
LED
2x
18
194
174
190
4.54.5
18
Transmitter for wireless signal transmission system for safety edges
Supplementary sheet to the original operating instructions
Intended use: Monitoring safety edges on doors and gates, in combination with the XRF-Rx receiver
ENGLISH
404301C
07/20
Carefully pull out
the PCB
Loosen screw
Plug in connector
Pairing is possible with open transmitter or later in mounted situation.
After initiating pairing on Rx:
Press button
(see receiver manual)
After initiating pairing on Rx,
press the edge two times within 2 sec.
Pairing (1.2) if required
Slide in the PCB again
Close the housing, tighten the screw
LED ashes 5x (conrms battery connected)
Delivery state Battery connected
1.1 Connect battery
1.2.a Pairing at open state 1.2.b Pairing at built-in state
1.2 Pairing
1Set-up
Battery 3.6. VButton
Screw
Button
Note:
Position of
red wire
Note:
Alignment of battery,
position of wire
PCB
Cable
with
plug
Wire
2
OK?
3x
Designed in Switzerland / Made in China
BBC Bircher Smart Access, BBC Bircher AG, Wiesengasse 20, CH-8222 Beringen, www.bircher.com
OK?
XRF-TI
Slide in the PCB
Close the cover again
System test mandatory!
Dispose battery acc. to local regulations
Order new battery (prepared with connector)
Pull out the PCB (see 1.1.)
Disconnect (the) plug and remove battery
Insert new battery, plug in connector
2Trouble shooting
2.1 Warning indicator for low battery voltage (1 – 2 months to cease operation)
1.4 System check
2.2 Battery change
Check the system
by pressing the safety edge
Every minute
Receiver
Beep
3Technical data
Input 8.2 kOhm
Battery power 1x Lithium Inorganic 3.6 V
Battery life Typ. 7 years
Operating frequency 868.3 MHz
4EU Declaration of Conformity
6Contact
5WEEE
Devices with this symbol must be treated separately during disposal. This must be done in accordance with the laws of
the respective countries for environmentally sound disposal, processing and recycling of electrical and electronic equipment.
XRF-TI is designed for the concealed installation in
the contact proles of ExpertSystem (see assembly
and mounting instruction).
However it can be wired with other saftey edges
eg. where space is limitted.
1.3 Mounting
Sensing
edge
Built-in
(e.g. sliding gate)
Surface mount
(e.g. industrial door with ClickLine)
To nd out which transmit-
ter has low battery
voltage: Press each edge.
Battery good Battery bad
Beep
Sensing edge
XL
Other Bircher Transmitter manuals
