Bissell POWERGLIDE LIFT-OFF PET User manual

QUICK START GUIDE 2043 SERIES
1. Slide handle into vacuum
base and attach with the
screw that is taped to the
handle.
2. Attach hose by lining
the tabs on the cu with
the notches on the back of
vacuum. Twist clockwise to
lock hose into place.
3. Push handle end into
base of vacuum on
opposite side.
4. Slide the Pet TurboEraser®
Tool holder down on the top
back of the base.
5. Slide the Crevice Tool/
Extension Wand holder
down onto the middle of
the back of base. Store
both tools in the holder.
Assembly Instructions
WARNING
Refer to the enclosed user guide for complete
instructions and important safety notices.
POWERGLIDE® LIFT-OFF PET
UPRIGHT VACUUM
161-1026 11/16 RevA
PARTS INCLUDED
Combination
Dusting/Crevice
Tool
Crevice Tool/
Extension Wand
Holder
Hose
Base Unit
Upper
Handle PetTurboEraser®
Tool Holder Pet TurboEraser® Tool Extension Wand
Pet Hair Eraser®
Tool (only available
select models)

QUICK START GUIDE 2043 SERIES
1. To use your optional Febreze®
filter (included), press the tank
release button and pull dirt tank
away from vacuum.
Optional Febreze® Filter
2. Remove the black/yellow
foam filter and replace with the
black Febreze®filter. Be sure to
place the Febreze®filter last,
covering the mesh filter. Place
dirt container back on vacuum.
Cleaning Filters
1. With vacuum unplugged,
remove the tank and lift up on the
tab attached to the filter cover.
There are 2 filters here; one foam
filter on top and a thinner fiber
filter; both are washable.
2. Remove post-motor filter
located on the front of the
vacuum underneath the filter
cover. If it appears dirty, remove
the filter and gently tap the filter
on the edge of a waste basket.
This filter is not washable.
3. Replace the post-motor filter
by pushing it straight back,
clicking each side.
Febreze® and related trademarks are owned by the Procter & Gamble Company,
Cincinnati, Ohio and used under license by BISSELL Homecare, Inc.