Bkav SmartHome SH-CTxR User manual

MODEL: SH - CTxRZW
by Bka v

Bkav SmartHome technology company limited
USER GUIDE
TOUCH SWITCH
SH - CTxRZW

Electric shock may cause injuries or threats to
life. Before installing, repairing or cleaning the
device, you should check whether the device’s
power is disconnected.
This work should be done by technicians or
Customer Contact Center to avoid electric
related accidents.
Environmental regulations must be complied when
discarding or recycling the device or its wrapping.
Thank you for choosing touch switch SH – CTxRZW of Bkav
SmartHome. By selecting Bkav SmartHome’s products, you
will get the best warranty service and installation support
from our technicians.
This document gives useful information during installation
and usage time. You should read and keep the manual
carefully in case of need.
1
Warning
Usage notice

Copyright © 2015 Bkav SmartHome Co., Ltd. All rights reserved.
The touch switch SH - CTxRZW is the product of Bkav
SmartHome and has been registered regarding design,
utility solutions and quality certification. All violations such as
copies of design and product idea are subject to the current
copyright law of the Socialist Republic of Vietnam.
2

Usage notice
Table of contents
Safety instruction
Introduction
General introduction
Product package
Specifications
Wiring diagram
Installation instruction
Device usage
Function of direct control
Function of advanced features
How to restore default mode
Software installation
Contact
1
3
4
5
5
6
7
8
9
12
13
13
14
15
16
3
Table of contents

Warning
Do not use voltage which is different from the one
stated in the device’s specifications.
Disconnect device’s power prior to any installation,
disassembly or repair.
Do not leave the device in high-temperature
environment.
Do not disassemble the device if not necessary.
Do not clean the device with corrosive chemicals.
Safety instruction should be complied during the
device usage.
4Safety instruction

General introduction
The touch switch SH - CTxRZW (*) is used to turn on/off
from 1 to 4 on/off channels. With the design of the
capacitive touch technology, anti-scratch Gorilla Glass,
unibody aluminum, the device will make your house convenient
and luxurious.
Besides, Wi-Fi or ZigBee connection makes it easier to install
the device in existing houses or brand new ones without
re-arranging electric lines or changing their infrastructure.
The device is suitable to control home appliances such as
night lamps, fans, televisions, curtains, blinds, etc.
5
Introduction
Notice (*) Model SH - CTxRZ:The device uses ZigBee technology.
(*) Model SH - CTxR:X is the quantity of controlled
channels of the device
(from 1 to 4 channels)
(*) Model SH - CTxRW: The device uses Wi-Fi technology.

Product package
Touch-screen
control panel
Power circuit box
Receptacle box
Connecting
cable
User guide (book) Set of screws
6
MODEL: SH - CTxRZW
by Bkav

Specifications
Operating voltage
Power rating
100-240V 50/60Hz
97 x 93 x 43 mm
240 gram
5A max/1 channel
Operating temperature
Wi-Fi band
Dimensions (L x W x H)
Weight
60ºC max
2.4GHz - 802.11b/g/n
ZigBee frequency 2.4GHz
7

4321
N
L
Wiring diagram
8
100-240V 50/60Hz
* The quantity of channel depends on the product type of 1, 2, 3 or 4 buttons
(refer to page 05)
Made by SmartHome
COMCOM
OUT
2.2
OUT
2.1
OUT
1.2
OUT
1.1
L
100-240
VAC
N
Disconnect device’s power prior to installation.
Voltage:
Power rating:
Operating temperature:
100-240V 50/60Hz
5A max
60ºC max
Smart touch switch
Model: SH - CT4RZW-P
Made in Vietnam
by Bkav

1
9
Unconnected wire
Power circuit box
Receptacle box
3
2
1
Installation instruction
Step 1: Connect the unconnected wires (2) from Receptacle
box (1) to Power circuit box (3) as in Figure 1 based on the
wiring diagram at page 8.

Step 2: Insert Power circuit box (3) into Receptacle box (1)
following the direction of the arrow, tighten 4 M4 screws (4)
to fix as shown in Figure 2.
10
Notice: Wire connector is always installed upwards.
2
M4 screw
Receptacle box
Power circuit box
Wire connector
3
4
1

3
Step 3: Connect the connecting cable (5) to Power circuit
box (3), then connect another cable’s head with the
Touch-screen control panel (6). Push the Touch-screen
control panel (6) towards the Power circuit box (3).
11
Receptacle box
Power circuit box
Connecting cable
Touch-screen
control panel
3
1
5
6
The green part of the connecting cable’s head is
always in an upward direction on connecting
Notice

12
Device usage
(*) The quantity of channel depends on the product type of 1, 2, 3 or 4 buttons
(refer to page 05)
Touch control button (*)
Status indicator light

Function of direct control
Function of advanced features
SH - CTxRZW uses the capacitive touch technology to turn
on/off electric devices just by gently tapping on the
corresponding icon on the glass. The indicator below the
icon is on, the corresponding status of the device is on. The
indicator below the icon is off, the corresponding status of
the device is off.
13
With control via Wi-Fi or ZigBee, SH – CTxRZW can get
commands from control interfaces which are set up in the
devices such as mobiles, tablets.
Besides, SH - CTxRZW can operate automatically based on
scenarios, schedules which are set up via software or operate
based on smart room system when connecting to other
devices.

14
How to restore default mode
Button 1: The button on the left or the button on top
left of the device.
Notice
To restore the default mode of the device, please follow ether
of the following ways:
Press and hold button 1 on the device for 15 seconds.
Use the function of default mode restoration of the device
on the control software.

15
You can download Bkav SmartDevice software to control the
device at: http://www.smarthome.bkav.com/SmartDevice
or scan QR Code below to download the application.
Software installation

If there is any problem related to the product, please contact
Customer Contact Center:
Customer Contact Center: (+1) 202 386 6779
Email: GlobalProject@bkav.com
16 Contact

The new home standard !

www.smarthome.bkav.com
UGCTxRZW/V1.0/0115
Mfr Code: 893604393HDCTxRZW
Copyright © 2015 Bkav SmartHome Co., Ltd. All rights reserved.
This manual suits for next models
2
Table of contents
Popular Switch manuals by other brands

NETGEAR
NETGEAR ProSafe GS728TP installation guide

HPE
HPE FlexFabric 5950 Series Configuration guide

Murphy
Murphy L971 Series Specifications

Camozzi
Camozzi SBT Series Use and maintenance instructions

Unipower
Unipower GRAVITAS SABRE 100A STS Installation & operating manual

WTI
WTI RPC-40L8A4 Series quick start guide