Black Mountain Products Pull Up Bar User manual

*Brackets optional.
Important: While this product has been manufactured and tested to decrease the risk of
injury, the potential for personal injury or property damage does exist. Therefore, the user
assumes all risks in the use of this product.
Before using this piece of equipment, make certain it is secure and correctly mounted in
doorway of appropriate size. If the doorway foundation is not stable or strong, DO NOT
USE this product in that location. It is the users responsibility to determine if the doorway
will safely sustain the proper use of the doorway pull up bar.
Important Safety Reminders:
•DO NOT swing or bounce when using this product.
•DO NOT attempt to hang by your feet or legs when using this product.
•DO NOT use this product if you weigh over 300 pounds.
•DO NOT use this product if you are unsure of the stability of the doorway or
door jam.
•DO NOT allow children under the age of 18 to use this product without adult or
professional supervision.
•DO test thoroughly to make sure your doorway pull up bar is completely secure
in the doorway before using it.
•DO maintain a controlled motion when performing exercises.
•If you have any concerns about your physical wellness, please contact your
physician before beginning any fitness program.
Warranty Support:
[e-mail]
Telephone: [phone]
Office Hours: 8-4 CST M-F
Black Mountain Products
Reach Your Peak Performance!
Pull Up Bar Assembly Instructions
1. Please refer to Diagram 1 to make sure all pieces of the
Pull Up Bar have been included.
2. Assembly requires an adjustable wrench and a Philips
screwdriver.
3. Follow instructions in order for proper assembly and safety.
4. Do NOT tighten down Bolts and Nuts until the Pull Up Bar
is fully together.
5. The provided Hex Nuts are LOCK Nuts and will not tighten
by hand.
6. The Pull Up Bar will fit residential doorways 24” to 32” wide
with a trim length at a maximum of 3 ½”, for a secure and
safe fit.
7. Questions or need help? Please call us at 815-322-2028
M-F 8-4 CST or e-mail us at
[e-mail].

Diagram 1
Note: Additional mounting brackets are included. Mounting brackets are NOT
required unless doorway does not have trim to stabilize the pull up bar.
Illustration of tightening Lock nut to Bolt. Use both wrench and screwdriver at
same time to tighten completely.
Step 1: Insert Left arm into Left Curved Handle. Align drilled holes. Repeat step
for right side. Note: Curved Handles are universal.
Step 2: Place Curved Handles on flat surface. Place Long Bar on top of Curved
Handles. Insert Bolts into Long Bar through both Curved Handles and Arms.
Place Lock Nuts on Bolts and tighten by hand. (Do Not Completely Tighten)
Repeat step for right side.
Step 3: Connect the Short Bar to Left and Right Arms with Lock Nuts and Bolts
with pad side facing long bar. Next, connect Left and Right handles to Right and
Left Curved Handles with Lock Nuts and Bolts tightening by hand.
Step 4: Tighten all Lock Nuts and Bolts securely with a wrench and Phlilips
screwdriver.
IMPORTANT: Please read safety information on back of manual before use of
Pull Up Bar.