Black Widow BW 4150 User manual

1
5-BUTTON NETWORK SERIES
VEHICLE SECURITY SYSTEM
Standard Features:
Status indicator (green LED)
Valet / override switch
Multi-tone siren
Dual stage impact detector
Remote panic
Remote chirp mute
Remote sensor/trigger bypass
Passive or active arming
Optional Features:
Flashing parking lights
Starter disable
Keyless entry
Remote trunk or hatch release
Illuminated entry
Hood and trunk protection
Remote auto start
Power window roll up
Back-up battery w/charging circuit
Glass break sensor
Plug-in radar sensor
Note: Some features may require additional parts
and labor, and may not be appropriate for certain
vehicles. Consult your authorized dealer.
System Operation
ARMING OPERATION
To arm the system press transmitter button 1:
• The siren will chirp once.
• The parking lights will flash once.*
• The doors will lock.*
• The LED will turn solid for 10 seconds
then start flashing slowly. After 10
seconds the system is armed.
AfterArming,if the system detects a bad sensor
or an open zone, the siren will chirp 4 times to
indicate a zone is open. The system will ignore
that input, but keep all other areas protected.
While the system is Armed, the system will
trigger if:
• The doors are opened.
• The shock sensor detects an impact to
the vehicle.
• The hood or trunk is opened.
When triggered, the siren will sound, the horn
will honk, and the parking lights will flash. If the
system is triggered by the ignition, doors, hood,
or trunk, the system will alarm for 40 seconds.
If triggered by the sensor inputs,the system will
alarm for 20 seconds.*
If the same input triggers the system 4 times
during a single arming cycle,the system will bypass
that input, keeping the other zones protected,
until the next time the system is armed.
If the shock sensor detects a light impact to the
car or the radar sensor detects an exterior
zone disturbance, the system win sound 5
chirps to warn away the potential intruder.
*Optional Feature
Owner’s Manual
5-Button
Transmitter
Button 1
Button 3
Button 2
Button 4
Button 5
BW4150 Owners.qxd 6/5/03 11:53 AM Page 1

2
PASSIVE ARMING
The passive arming feature allows the system to
arm automatically without user intervention.
This programmable feature may be enabled during
installation.
To arm the system passively:
1. Turn the ignition key off.‡
2. Exit the vehicle and close all doors.
• The LED will start flashing rapidly to
indicate that the system is preparing to
arm. (The system can be armed at any
time by pressing transmitter button 1.)
• The siren will chirp 30 seconds after
the last door is closed to indicate the
system is now armed.
• The doors will lock.†*
‡The ignition must have been on for at least 10
seconds prior to exiting the vehicle or PassiveArming
will be bypassed.
†If the Passive Locking feature was enabled during
installation.
DISARMING OPERATION
To disarm the system press transmitter button 2.
• The siren will chirp twice.¥
• The parking lights will flash twice.¥*
• The doors will unlock.†*
• The dome light will turn on for 30
seconds.*
¥If the alarm was triggered while away, the system will
respond with 3 chirps and 3 parking light flashes.
†If the Passenger Unlock Feature is enabled, pressing the
unlock button will unlock only the driver's door. Pressing the
unlock button again unlocks all doors.
*Optional feature
TAMPER ALERT
If the alarm was triggered while away from the
vehicle,the siren will chirp 3 times on disarming
for tamper indication. After disarming the
alarm, enter vehicle and turn ignition on. The
LED will flash the zone that was triggered 5
times (see LED chart).
AUTO REARM
The Auto Rearm feature allows the system to
automatically re-arm itself in the event the
system is disarmed and a door is not opened
within 30 seconds. This programmable feature may
be disabled during installation. The Passive Arming
feature and Auto Rearm feature are related. In order
to disable the Auto Rearm feature,the Passive Arming
feature must also be disabled during installation.
NOTE: This feature will not work on vehicles with
the illuminated entry feature enabled.
SILENT ARMING/DISARMING
Press transmitter button 5 (the Shift Button)
then the Arm or Disarm button for one-time
silent operation. The system can also be
programmed for full-time silent operation
during installation.
CHIRP DELETE
For full time silent operation, the ARM/ DISARM
chirps can be permanently disabled. This feature
must be programmed during installation.
IGNITION LOCK*
The ignition locking feature allows the doors to
automatically lock when the ignition key is
turned on, and automatically unlock when the
ignition key is turned off. This feature may be
disabled during installation.
*Optional feature
BW4150 Owners.qxd 6/5/03 11:53 AM Page 2

3
REMOTE PANIC
In the event of an emergency (PANIC) situation,
the system’s siren can be triggered for 45
seconds to attract attention.To activate the Panic
Feature, press transmitter button 1 for 3
seconds:
• The siren will sound.
• The parking lights will flash*.
Press button 1 to exit panic mode and rearm
the system. Press button 2 to exit panic mode
and disarm the system. The Panic Feature will
operate when the ignition is on.
*Optional feature
EMERGENCY OVERRIDE
If the transmitter becomes lost or fails to
operate, the system can be disarmed by using
the emergency override feature.
To override the system:
1. Enter the vehicle.
• Because the system is armed, the siren
will sound.
2. Turn on the ignition key.
3. Press the Valet switch for 3 seconds.
• The siren will stop sounding.
• Starter defeat bypassed.
VALET MODE
When the system is placed into theValet Mode
the security system will be disabled.
However, the optional keyless entry and trunk
release features will still function if installed.
To enter the Valet Mode:
1. Be sure the system is disarmed.
2. Turn the ignition key on.
3. Press and hold the valet/service mode
switch for 3 seconds.
• The siren will chirp once.
• The LED will turn on solid indicating
the system is in Valet Mode.
To exit Valet Mode:
1. Turn the ignition key on.
2. Press and hold the valet/service mode
switch for 3 seconds.
• The LED will turn off.
• The Siren will chirp 2 times.
OPTIONAL TRUNK RELEASE
Press button 3 for approximately 2 seconds to
open the trunk.
OPTIONAL TRUNK DISARM
The trunk disarm feature allows the alarm to
disarm automatically whenever transmitter
button 3 is used to activate the optional trunk
release. This eliminates having to first disarm
the alarm before activating the trunk release.
This feature must be programmed during
installation.
REMOTE SENSOR BYPASS
To arm the system and bypass the shock sensor,
press button 1 to arm, then within 2 seconds
press button 1 again.The siren will chirp 5 times
and sensors will be ignored until the system is
disarmed and rearmed.
OPTIONAL SECURE OVERRIDE CODE
If your system was programmed to override
with a personal override code-pressing the
over-ride switch from 1 to 15 times.
To disarm the system with your personal over-
ride code please use the following steps:
1. Open Door,Alarm system will trigger
2.Turn ignition key to on
3. Press the over-ride switch to the selected
number of times and hold on the last one for
10 seconds until the alarm turns off.
BW4150 Owners.qxd 6/5/03 11:53 AM Page 3

4
TRANSMITTER FUNCTION
Button #1 arm with chirps, press 3 seconds for
panic
Button #2 disarm with chirps and press 2 times
for passenger unlock
Button #3 press for 2 seconds for Auxiliary 1
function (trunk/hatch release)
Button #4 press for Auxiliary 2 function
Transmitter Functions with Shift Key
(Button #5) pressed 1 time prior:
Button #1 arm without chirps
Button #2 disarm without chirps
Button #3 press for Auxiliary 3 function
Button #4 press for remote start, if using
network port start module
Transmitter Functions with Shift Key
(Button #5) pressed 2 times prior:
Button #1 arm with chirps on second vehicle
Button #2 disarm with chirps on second vehicle
Button #3 Trunk release or Auxiliary 1 function
on second vehicle
Button #4 press for remote start on second
vehicle, if using network port start module
Transmitter Functions with Shift Key
(Button #5) pressed 3 times prior:
Button #1 not used
Button #2 not used
Button #3 Sensor Test Mode
Button #4 not used
OPTIONAL FEATURES
Some features and options may require
additional parts and labor, and may not be
appropriate for certain vehicles.
• Dome light elimination
• Horn honk
• Dual stage unlock
• Remote Autostart
• Power window roll-up
STATUS INDICATOR (LED) FUNCTIONS
On Solid = Valet Mode
Slow Flash = System Armed
Rapid Flash = Passive Arming
TAMPER ALERT LED FUNCTIONS
1 flash = sensor #2
2 flashes = shock sensor
4 flashes = door
5 flashes = hood or trunk
flash-flash-pause-flash-flash-pause = shock sensor
PARKING LIGHTS FUNCTIONS
On Solid = Vehicle Remote Starting
Flash 1x = System armed
Flash 2x = System disarmed
Flash 3x = Open Zone Indication (after arming)
© DLC, Inc. 64-4150 Rev. 1, 09/02
BW4150 Owners.qxd 6/5/03 11:53 AM Page 4