Blaupunkt SB-01 User manual

SB-01
ThunderBase
Instruction Manual
ThunderBase
Touch Control | Built-in Woofer | DSP Technology

SB-01
2
ENGLISH
Important Safety Instructions
1. Read these instructions.
2. Heed warnings.
3. Follow all instructions.
4. Do not use this apparatus near water.
5. Clean only with dry cloth.
6. Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
7. Do not install near any heat source such as radiators, heat registers, stoves, or
other apparatus (including ampliers) that produce heat.
8. Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding
type plug has two blades and a third grounding prong. The wide blade or the
third prong is provided for your safety. If the provided plug does not t into
your outlet, consult an electrician for replacement of the obsolete outlet.
9. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
10. Only use attachments/accessories specied by the manufacturer.
11. Unplug the apparatus during lightning storms or when unused for long
periods of time.
12. Servicing is required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
13. Battery
1). CAUTION: Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type.

SB-01
3
ENGLISH
2). Warning: DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD.
•This product contains a coin/button cell battery. If the coin/button cell
battery is swallowed, it can cause severe internal burns in just 2 hours and
can lead to death.
• Keep new and used batteries away from children. If the battery
compartment does not close securely, stop using the product and keep it
away from children.
• If you think batteries might have been swallowed or placed inside any part
of the body, seek immediate medical attention.
14. This equipment is a Class II or double insulated electrical appliance. It has
been designed in such a way that it does not require a safety connection to
electrical earth.
Warning
This appliance is not intended for use by persons (including children)
withreduced physical sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
1. To prevent possible hearing damage, do not listen at high volume levels
for long time periods respectively a sudden high volume level.
2. Never use the device unsupervised! Switch o the device whenever you are
not using it, even if this only for a short while.
3. The appliance is not intended to be operated by means of an external timer or
separate remote control system.
4. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualied persons in order to avoid a hazard.
5. Before operating this system, check the voltage of this system to see if it is
identical to the voltage of your local power supply.

SB-01
4
6. The unit should not be impeded by covering the ventilation opening with
items such as newspaper, table-cloths, curtains etc. Make sure that there are at
least 20 cm of space above and at least 5 cm of space on each side of the unit.
7. The apparatus must not be exposed to dripping or splashing and that objects
lled with liquids, such as vases, must not be placed on the apparatus.
8. To prevent re or shock hazard, do not expose this equipment to hot places,
rain, moisture or dust.
9. Do not locate this unit near any water sources e.g. taps, bathtubs, washing
machines or swimming pools. Ensure that you place the unit on a dry, stable
surface.
10. Do not place this unit close to a strong magnetic eld.
11. Do not place the unit on a amplier or receiver.
12. Do not place this unit in a damp area as the moisture will aect the life of
electric components.
13. If the system is brought directly from a cold to a warm location, or is placed in
a very damp room, moisture may condense on the lens inside the player. If this
occurs, the system will not operate properly. Please leave the system turned
on for about an hour until the moisture evaporates.
14. Do not attempt to clean the unit with chemical solvents as this might damage
the nish. Wipe with a clean, dry or slightly damp cloth.
15. When removing the power plug from the wall outlet, always pull directly on
the plug, never pull on the cord.
16. The mains plug is used as the disconnect device, the disconnect device must
remain readily operable.
ENGLISH

SB-01
Caution
To reduce the risk of electric shock, do not dismantle the product and do not
expose the apparatus to rain or moisture. No user-serviceable parts inside. Refer
servicing to qualied personnel only.
Explanation of Graphical Symbols:
The lightning ash within an equilateral triangle is intended to
alert you to the presence of un-insulated dangerous voltage
within the product's enclosure that may be of sucient magni
tude to constitute an electric shock to a person or persons.
The exclamation point within an equilateral triangle is intended to
alert you to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying
the product.
To achieve the utmost in enjoyment and performance, and in order to become
familiar with its features, please read this manual carefully before attempting to
operate this product. This will assure you years of trouble free performance and
listening pleasure.
Important Notes
• This safety and operating instruction should be retained for future reference.
• The apparatus should not be exposed to dripping or splashing or placed in a
humid atmosphere such as a bathroom.
• Do not install the product in the following areas:
• Places exposed to direct sunlight or close to radiators.
• Blocking ventilation or in a dusty area.
5

SB-01
• Areas where there is constant vibration.
• In Humid or moist places.
• Do not place near candles or other naked ames.
• Operate the product only as instructed in this manual.
• Before turning on the power for the rst time, make sure the power adaptor is
properly connected.
• For safety reasons, do not remove any covers or attempt to gain access to the
inside of the product. Refer any servicing to qualied personnel.
• Do not attempt to remove any screws, or open the casing of the unit; there
are no user serviceable parts inside. Refer all servicing to qualied service
personnel.
CAUTION: Any changes or modications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment
IDENTIFYING THE PARTS
Top View
1. LED Display window
- Showing working modes including Bluetooth, Optical, Coaxial, Aux-in, USB.
2. Remote sensor
6
ENGLISH

3.“ – “ Button
- Press to decrease the volume level.
4.“ +” Button
- Press to increase the volume level.
5.“ ” Button
- Press to choose music mode.
6.“ ” Button
- Short press to turn on/o the unit.
Back View
7. Optical Socket
8. Coaxial Socket
9. RCA (L, R) Socket
10. 3.5mm Aux-in Socket
11. AC- IN Socket
12. USB Port
Bottom View
13. Subwoofer
SB-01
7

SB-01
Remote Control
1. : Switch the unit between ON and STANDBY mode.
2. : Press to adjust volume level up.
3. : Press once to return to the beginning of current
track or previous track.
4. : Press to adjust volume level down.
5. : Press once to advance to the next track.
6. In USB or Bluetooth mode, start or pause playback.
-If the speaker is already connected via Bluetooth and
you would like to connect to a dierent device, press
and hold for 3 seconds to break the current connection
and initiate pairing.
7. MODE: Press to switch the operating mode.
8. MUTE: Mute or resume the sound.
Note: When Mute is on, the LED will ash slowly.
9. MUSIC: Press to choose Music surround sound eect.
10. MOVIE: Press again to choose Movie sound eect.
PREPARATIONS
Prepare the Remote Control
The provided remote control allows the unit to be operated from a distance.
• Even if the Remote Control is operated within the effective range (up to 6m),
remote control operation may be impossible if there are any obstacles between
the unit and the remote control.
• If the Remote Control is operated near other products which generate infrared
rays, or if other remote control devices using infra-red rays are used near the
unit, it may operate incorrectly. Conversely, the other products may operate
incorrectly.
8
ENGLISH

SB-01
9
Precautions Concerning Batteries
1. When the Remote Control is not to be used for a long time (more than a
month), remove the battery from the Remote Control to prevent it from
leaking.
2. If the batteries leak, wipe away the leakage inside the battery compartment
and replace the batteries with new ones.
3. Do not use any batteries other than those specied.
4. Do not heat or disassemble batteries. Never throw them in re or water.
5. Do not carry or store batteries with other metallic objects. Doing so could
cause batteries to short circuit, leak or explode.
CONNECTING AN EXTERNAL DEVICE USING 3.5-RCA ADUIO (ANALOG) CABLE
OR COAXIAL/OPTICAL (DIGITAL) CABLE
*Not all TVs have the audio outputs shown above. To connect the Sound base
directly to your other devices (Blu-ray player, game system, etc) see your device’s
user manual.
Connect Power
• Ensure that the power supply voltage corresponds to the voltage printed on
the back or the underside of the unit.

ENGLISH
SB-01
10
• Before connecting the AC power cord, ensure you have completed all other
connections.
• Connect the mains plug of the main unit to a mains socket.
• Ensure all connections are connected before connecting to the mains
power socket.
BASIC OPERATION
ON/OFF
• Short press button on the main unit or press the button on the remote
control to switch the main unit on. The LED Display window will light on.
• Press and hold the button on the main unit or press the button on the
remote control to switch the main unit o. The LED Display window will light
o.
Select Modes
Short press the button on the main unit or the MODE Button repeatedly to
select dierent input mode.Notes:
Notes:
• The LED display will go off automatically if the sound base is sitting idle and no
input signals are being received for about 5 minutes, press any button once to
light up the display again.
• When the sound base is sitting idle and no input signals are being received for
about one hour, the sound bar will automatically switch to Standby mode.