Bloomfield POD2 User manual

AT LEAST ONE COPY OF THIS MANUAL SHOULD BE KEPT IN A LOCATION AVAILABLE AT
ALL TIMES TO MAINTENANCE AND MANAGEMENT STAFF.
10 Sunnen Drive – St. Louis, MO 63143
MODEL POD2 DUAL POD BREWER
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, and/or injury to persons, including the following:
1. Read all Instructions.
2. Do not touch hot surfaces. Use handles or knobs.
3. To protect against fire, electric shock and injury to persons do not immerse cord, plugs, or the
appliance in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or
taking off parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions,
or has been damaged in any manner. Return appliance to the nearest authorized service
facility for examination, repair or adjustment.
7. The use of accessory attachments not recommended by the appliance manufacturer may
result in fire, electric shock or injury to persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. Prior to connecting or disconnecting plug from wall outlet, turn any control to “off”.
12. Do not use appliance for other than intended use.
13. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT OPEN BASE.
NO USER SERVICABLE PARTS INSIDE. REPAIR SHOULD BE DONE BY AUTHORIZED
PERSONNEL ONLY.
SAVE THESE INSTRUCTIONS
CORD SET INSTRUCTIONS
A short power-supply cord is provided to reduce risks resulting from becoming entangled in or
tripping over a longer cord. Extension cords are available and may be used if care is exercised in
their use. If an extension cord is used, the marked electrical rating of the extension cord should be
at least as great as the electrical rating of the appliance; the extension cord should be a grounding
type 3-wire cord; and the longer cord should be arranged so that it will not drape over the counter
top or table top where it can be pulled on by children or tripped over.
This appliance has a grounded plug (3 prong). It is not polarized and can fit into an outlet only one
way. If it does not fit into the outlet, contact a qualified electrician. Do not attempt to modify the plug
in any way.
WARNING: SERVICING SHOUD BE PREFORMED BY
AUTHORIZED SERVICE FACILITY
P2_1311a

AT LEAST ONE COPY OF THIS MANUAL SHOULD BE KEPT IN A LOCATION AVAILABLE AT
ALL TIMES TO MAINTENANCE AND MANAGEMENT STAFF.
10 Sunnen Drive – St. Louis, MO 63143
MODEL POD2 DUAL POD BREWER
PREPARATION FOR USE
Before the first use, clean the brewer by completing a brew cycle as described below without using
a coffee pod.
BREWING COFFEE
1. Place brewer on a solid flat surface. Plug into 120V outlet.
2. Open filter basket by grasping basket handle and swinging outward. Insert a coffee pod into
filter basket. Use a fresh coffee pod for each brew. Return basket to closed position. To assure
safe operation, make sure basket is closed securely.
3. Lift the hinged water reservoir cover; pour water into reservoir opening. Marking on water level
indicator shows amount of water needed to make desired number cups of coffee. FOR 1 CUP,
DO NOT EXCEED 1-CUP LEVEL ON THE WATER LEVEL INDICATOR. FOR 2 CUPS, DO
NOT EXCEED 2-CUP LEVEL ON THE WATER LEVEL INDICATOR. Close reservoir cover.
4. To brew 1 cup on left side, place cup onto drip tray on left, press left “BREW” button. To brew
1 cup on right side, place cup onto drip tray on right, press right “BREW” button. To brew 2
cups (one on each side), place two cups onto drip tray, press left and right “BREW” buttons.
LED will light. CAUTION: Brewer becomes very hot during brew cycle; handle with extreme
care as hot parts and escaping steam may cause burns.
5. At end of brew cycle, LED will flash and audible beep will signal brewing is complete. LED will
turn off, and brewer will switch off automatically.
6. After brewer and coffee pod(s) have cooled, carefully open filter basket and discard used
coffee pod(s). To remove filter basket from brewer, grasp basket handle and swing basket
outward, and with basket in far right position, lift up basket.
CLEANING AND MAINTENANCE
Always unplug brewer and allow to cool before cleaning. Wash filter basket in hot, sudsy water.
Wipe brewer with damp cloth and dry. Never put brewer in water or in the dishwasher. For hard to
remove stains, use a plastic mesh pad or a cloth dampened in vinegar. Do not use metal cleaning
pad or abrasive cleaners.
Minerals found in water can clog brewer or reduce its efficiency. To prevent this, add a mixture of
1/3 vinegar and 2/3 water to water reservoir. DO NOT OVERFILL. Place cup on drip tray and press
“BREW” buttons. After mixture has been cycled through, press “STOP” button. Rinse by cycling
through 2 or 3 more cycles of plain cold tap water. Do not pour any liquid other than cold tap water
or water with vinegar into reservoir opening when cleaning.

WARNING: SERVICING SHOUD BE PREFORMED BY
AUTHORIZED SERVICE FACILITY
P2_1311a