Blue Wave Grand Oasis User manual

11
Part 6 DRAINAGE AND STORAGE Part 7 CONTROL UNIT FUNCTION
1. Drainage System
Locate the stopper and drain cap on the boom of the SPA. Remove both and completely drain all water
from the SPA.
2. Dry the Spa and Control Unit
Aer a GFCI test, press the jet massage buon to blow out the water inside the jet holes. Unplug the pump,
remove the filter cartridge from the control box and dry the pump by draining all water from pump body
and pipes. Open the drain valve on the boom of pump, let the water flow out and refasten the drain valve.
3. Storage
Use a towel to wipe off the SPA, then let air dry for 24 hours. Unscrew the air valve on both the SPA and lid.
When the SPA and lid have been completely deflated, gently fold them for storage. It is recommended that you
store the SPA in its original package in a warm dry place.
A. Increase Temperature
Buon
D. Filter Buon
E. Heat Buon
G. Temperature Mode Buon
F. LED Display
FUNCTIONS OF SPA PUMP
10
B. Decrease Temperature
Buon
C. Blower/Jet
Massage Buon
• LED Display: Once powered-up the LED display (F) will show the current water temperature automacally.
• ‘Temperature Adjustment’ buons (A & B): Increase (A), Decrease (B). Pressing one of the temperature
adjustment buons will cause the LED Display to flash. When it is flashing, you can set the desired temperature.
The value will increase or decrease by 1°C/1°F each me you press the buon. If you hold the buon for 2
seconds, the values will increase/decrease rapidly.
• Temperature Adjustment Ranges: Celsius mode: 30°C - 39°C / Fahrenheit mode: 86°F - 103°F. To lock the
Control unit, press (A) + (B) at the same me and hold them for 3 seconds. When the spa is le unaended you
can lock the Control Unit to avoid having the sengs changed. Unlock the Control Unit by pressing (A) + (B) at
the same me and hold for 3 seconds again.
• ‘Temperature Mode’ buon (G): Press this buon to change from Celsius to Fahrenheit.
• ‘Jet Massage’ buon (C): Acvates jets. Press this buon to acvate the massage system, the green indicator
light turns on. It can be turned off by pressing it again.
NOTE:
a) The massage system will stop automacally aer 30 minutes of operaon. Re-acvate the jet funcon by
pressing the jet buon again.
b) When the Filter mode is on, pressing the Jet Massage buon (C) will cause the Filter mode to turn off and the
Jet Massage mode to turn on.
c) Heang and jet funcon cannot be acvated at the same me. When heang system is working, pressing (C)
will change heang mode into jet mode: heang and filtering are shut down, jet system will be acvated. If you
press (C) again, heang and filtering mode will re-start.
d) Pressing Filter buon (D) acvates Filter System. This buon turns the pump on and off. The green indicator
light will turn on when the filtraon system is acvated.
Note: When heang and filter funcons are working at the same me, pressing (D) will shut down heang and
filtering together. When (C) is on, filter and heang cannot be acvated, therefore (C) should be shut down first.
e) Pressing the Heat buon (E) acvates the heang and filtering system at the same me. The green Filter light
and red Heat light will be acvated at the same me. The pump does not stop heang unl the current water
temperature reaches the set temperature indicated by the ‘blinking’ red light.
f) When you press the Blower buon (C) the Circulaon Pump and the heater will stop, as a consequence the
temperature on the display decreases (due to no flow of water between the control unit and the spa). To regain
heat turn the blower buon (C) off and press the heat buon (E), the Circulaon Pump will restart and the
temperature will increase or the heang mode will restart automacally aer the water temperature drops
1°C/1°F (approx.) below the set temperature. Max. heat temperature: 39°C (103°F).
Allow 24-48 hours to heat up your spa.
PORTABLE SPA WARRANTY
1. This spa has a 2-Year Warrantyagainst defects in materials and workmanship.
2. Please nofy Blue Wave Products in advance of anyspa warrantyclaim prior to shipping the spa back.
Contact our warranty claim department at [e-mail].
3. Ifthe warrantyclaim department determines that the item must be returned,it must be returned with
a receipt showing date of purchase, purchase price, and the dealer from which the spa was purchased.
No warranty claim will be honored without a receipt.
4. The freight on the item when returned must be prepaid.
5. Warrantyclaims will only be resolved with the repair of the current product or shipment of a replacement
product. NO REFUNDS will be given.
6. Improper installaon, misuse or damages resulng from acts of nature will render this warrantynull
and void. Note addional examples of misuse and abuse on page 12.
7. This warrantyis in lieu of all other warranes expressed or implied and no responsibilityis assumed for
future damage due to misuse. We are not responsible for damage to the sauna due to improper installaon
or misuse.Addional acons that will void the warrantyare listed on Page 12 and are considered as part
of this warranty.