Bluedio Fi TWS User manual

User Manual for Bluedio Fi TWS
Bluetooth Earphones with Touch
Sensor

Specifications:
- Bluetooth version: v5.0
- Bluetooth profiles: HSP, HFP, A2DP, AVRCP
- Wireless range: up to 10m
- Speaker units: 2 x 6mm
- Music time: up to 10h
- Charging box capacity: 650mAh
1. Charging contact
2. Touch switch
3. Microphone
4. LED indicator
5. Charging indicator
6. Charging thimble
7. Charging socket
8. Charging slot
9. Charging box

The first use
Open the charging box cover, earphones will light up. When the earbuds are
successfully paired, they will flash quickly and wait for the phone connection. Take
your phone, open Bluetooth, and search for “Fi R” (or “Fi L”), wait for the pairing
request to pop up, tap it and pair the earphones.
If the earbuds pairing request doesn’t pop up, please delete the connected
earbud pairing ID, press the touch key of that earbud three times to remove the
pairing recording, and they try to pair again.
Turnin on/off:
Long-touch the earbud for about 3 seconds until you hear a voice prompt. The
other way is to open/close the charging box.
Connecting both earbuds to your device
If the earbuds are not connected, they’ll shut down automatically. Tap them
three times to restart them; they’ll enter pairing mode and you’ll see the LED light
flash quickly.
When earphones are connecting, you’ll hear the voice prompt and see both
earbuds light up meaning that they are successfully paired with your device. There
also might be a voice prompt of failed connection, and the earphones will
automatically turn off if they can’t connect successfully in 3 minutes.
Music and call control
To play/pause the music, touch the earbud once. Double touch the right
earbud to increase the volume, and double touching the left earbud decreases
volume. Triple touch changes the song: left earbud for the previous song and right
earbud for the next song.
To answer/end a call tap once and to reject hold for 1 second. To redial the
last phone number, you have to tap the earbud four times. You’ll hear a voice prompt
of dialing the last number.
Charging the earphones and the charging box
Put back the earphones into the charging box and close it. The continuous
white light on the box shows that the earphones are charging. When they are
charged, the light will go off.
When charging the box, continuous red light means that the box is charging.
When the charging box is fully charged, the light will turn white. If you see the box
has a flashing red light, it means that the charging box has low power and needs to
be charged.