Boca Flasher CCS-100 User manual

Installation Manual
CCS-100
WARNING: DO NOT ATTEMPT TO INSTALL OR USE THE
CCS100 FIXTURE WITHOUT READING THE INSTALLATION
INSTRUCTIONS AND SAFETY LABELS COMPLETELY.
Failure to adhere to these instructions could result in serious injury or property damage.
DO NOT MODIFY, ALTER OR ATTEMPT TO SERVICE THE CCS100. DOING SO WILL VOID THE WARRANTY.

Installation Instructions
CCS100
DMX Controlled Dimmable LED Light Strips
Fixtures must be installed by a
qualied and licensed electrician in
accordance with all national, state and
local electrical codes and regulations.
If any part of this manual does
not meet the necessary codes and
regulations, contact the factory for
more information before attempting
to install.
Model Dependent
Max temp: 55C
Min. temp: -40C
DAMP LISTING
IP65
WET LISTING
IP68
Turn Power Off At Circuit Breaker Before Beginning Installation!
INCLUDED IN THIS PACKAGE:
OR
Tube
Underwater Tube
Mounting Brackets
(2 brackets per xture)
Remote Transformers
(If ordered)
12 3
PAGE 2 OF 6
CCS100 Fixtures
(In lengths shown on job specic drawings)
4I.M.C.S. Distribution Box
(If ordered)
5Job Specic Drawings
AC100
Introduction:
The Boca CCS100 is designed for low power applications where energy consumption and size are the main concerns. It can be specied
with either one row or two rows, depending on the light output required. It oers seamless LED conguration, easy installation, and vibrant
monochromatic color. The CCS100 can be used with any magnetic low voltage dimmer and is available in dierent housings for dierent uses,
including underwater installations where IP68 is required.
Maintenance:
CLEANING Dry and Damp (IP65) Rated Fixtures: To clean surface use a soft damp cloth.
Wet (IP68) Rated Fixtures: To clean surface use a soft cloth with mild soap and water.
STORAGE Store in a dry, well-ventilated area when product is not in use.
Keep the electrical cord away from heated surfaces when in use or not in use.
If cord shows signs of damage do not use, return product to manufacturer.
Electrical Specifications:
1. Input Voltage: 24 VDC or 24 VAC
(See layout drawings for spec.)
2. Total linear ft per distribution box:
80 ft (10 ft per port)
3. Total linear ft per 100watt transformer: 22 ft
4. Total linear ft per 300watt transformer: 66 ft
5. Input Current: 150mA RMS per linear ft
For Underwater Tube For Tube
OR
Power
Supply

2. INSTALL FIXTURES INTO CLIPS
Installation Instructions
CCS100
PAGE 3 OF 6
1. INSTALL CLIPS INTO SUBSTRATE
Push Fixture down with slightly rm pressure.
1a 1b Screw Information:
1. Screws not provided by Boca Flasher.
2. For Tube Boca, Flasher recommends
wide washer at head Philips #8
screw. (not to exceed .418”)
For Underwater Tube, Boca Flasher
recommends Philips #8 screw.
(not to exceed .330”)
3. Length of screw will vary depending
on mounting surface.
4. For outdoor installations, installer should
use a screw with weatherproof coating.
2a Clip will securely snap into place.
2b
OR
snap!
▶
▶
OR
▶
▶
3. CONNECT FIXTURES TOGETHER FOR TUBE ONLY
AS SHOWN ON JOB SPECIFIC DRAWINGS NOTE: Underwater Tube ships connected.
Connect Male and Female connectors
in order shown on job
specic drawings.
3a 3b
Coupler
Push together until
you hear a “Click”.
3c
click!
▶
▶
*For vertical installation, please contact the factory for specic mounting instructions.
OR OR

4 CONNECT FIXTURES TO POWER
Installation Instructions
CCS100
PAGE 4 OF 6
24VAC
Power
Supply
24DC
Power
Supply
Note:
If contractor wishes to hard wire xture,
cable can be stripped of Edison plug and
hardwired using a junction box.
Molded cable must be encased in conduit.
▶
By others.

Installation Instructions
CCS100
IMPORTANT SAFETY REMINDERS:
We are constantly improving our fixtures and reserve the right to change options and specifications. Additional information &
details at www.bocaflasher.com. For specific requirements, contact your Boca Flasher sales representative. Boca Flasher, Inc. 508
S. Military Trail, Deerfield Beach, Florida 33442 USA Phone: 561.989.5338 Fax: 561.982.8323 © 2017 Boca Flasher, Inc. All rights
reserved. All names and trademarks are property of their respective owners. REV 06-2017
DAMP LISTING
IP65
WET LISTING
IP68
1. DANGER:
To reduce the risk of electric shock, always unplug the CCS100 from electrical outlet before
cleaning. Cut breaker if outlet is not available.
2. To reduce the risk of burns, re, electric shock or injury to persons:
• UsetheCCS100onlyforitsintendeduseasdescribedintheseinstructions.
• DonotuseattachmentsnotrecommendedbyBocaFlasher.
• NeveroperatetheCCS100ifithasadamagedcordorplug,ifitisnotworking
properly, if it has been dropped or damaged, or dropped into water. If the seal appears
to be damaged/broken/torn return the CCS100 to a service center for examination or repair.
• Keepcordawayfromheatedsurfaces.
• Neverdroporinsertanyobjectintoanyopening.
• Donotoperatewhereaerosol(spray)productsarebeingusedorwhereoxygenis
being administered.
3. WARNING:
Do not attempt to install or use the CCS100 without reading the installation instructions
and safety labels. Failure to adhere to these instructions could result in serious injury or
property damage.
4. Do not modify, alter or attempt to service the CCS100:
Doing so will void the warranty.
5. Do not use sharp tools near or on the xture lens:
Doing so will result in property damage and void the warranty.
Boca Flasher, Inc.
508 S. Military Trail nDeerfield Beach, Florida n33442 USA
Phone: 561-989-5338 nFax: 561-982-8323
www.bocaflasher.com
Table of contents