Bogen RPK900 User manual

www.bogen.com
RPK900
Model
SINGLE/DUAL UNIT
RACK MOUNT KIT
INSTRUCTION MANUAL
19”
8.4”
1.73”
Dual Rack Mount Adapter
Single Unit
Blank Panel
Included Accessories:
Dual Unit Rack Mount Adapter (1),
Single Unit Blank Panel (1), M3 Screws (8),
BNCF/F Panel Adapters (2),
BNC Cables (2), Plastic Hole Plugs (2)
Installation/Use Instructions:
1. Before mounting the UDR8011 Receiver into the
Dual Rack Mount Adapter, release any cables
from the rear of the receiver.
2. The UDR8011 Receiver can be placed in either the
Left or Right position. Rotate the Dual Rack Mount
Adapter and the UDR8011 Receiver upside-down
and insert the UDR8011 through one of the front
openings (Fig. 1).
3. Line up the UDR8011’s mounting holes with the Dual
Rack Mount Adapter’s mounting holes. Insert and tighten
the four (4) screws provided (Fig. 2).
4. Repeat Steps 1-3 when installing a second UDR8011
Receiver unit.
5. If only one UDR8011 unit is being installed, attach the
Single Unit Blank Panel with the remaining four (4)
screws provided to cover the open space (Fig. 3).
6. Install the two (2) Plastic Hole Plugs into the Single Unit
Blank Panel, or install the provided two (2) BNCF/F
adapters and cables, if necessary to relocate the
antennas to the front of Single Unit Blank Panel (Fig. 4).
FRONT VIEW
SIDE
VIEW
1. SINGLE UNIT BLANK PANEL
2. SINGLE UNIT BLANK PANEL
ANTENNA HOLE(S)
3. ANTENNA(S)
4. BNCF/F PANEL ADAPTER
5. BNC CABLE
1
2
3
4
5
1
2
2
3
3
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)

www.bogen.com
©2018 Bogen Communications, Inc.
Specifications are subject to change.
740-00077A 1810
19”
8.4”
1.73”
Dimensions:
(Inches)
The Bogen RPK900 Single/Dual Unit Rack Mount Kit is warranted to be free from defects in material and workmanship for one (1) year from the
date of sale to the original purchaser. Any part of the product covered by this warranty that, with normal installation and use,
becomes defective (as conrmed by Bogen upon inspection) during the applicable warranty period will be repaired or replacedby Bogen,
at Bogen’s option, provided the product is shipped insured and prepaid to: Bogen Factory Service Department, 4570 Shelby Air Drive, Suite 11,
Memphis, TN 38118 USA. Repaired or replacement product(s) will be returned to you freight prepaid. This warranty does not extend to any
of our products that have been subjected to abuse misuse, improper storage, neglect, accident, improper installation or have been modied
or repaired or altered in any manner whatsoever, or where the serial number or date code has been removed or defaced.
THE FOREGOING LIMITED WARRANTY IS BOGEN’S SOLE AND EXCLUSIVE WARRANTY AND THE PURCHASER’S SOLE AND
EXCLUSIVE REMEDY. BOGEN MAKES NO OTHER WARRANTIES OF ANY KIND, EITHER EXPRESS OR IMPLIED, AND ALL IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DISCLAIMED AND EXCLUDED TO
THE MAXIMUM EXTENT ALLOWABLE BY LAW. Bogen’s liability arising out of the manufacture, sale or supplying of products or their use or
disposition, whether based upon warranty, contract, tort or otherwise, shall be limited to the price of the product. IN NO EVENT SHALL BOGEN
BE LIABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, LOSS OF PROFITS,
LOSS OF DATA OR LOSS OF USE DAMAGES) ARISING OUT OF THE MANUFACTURE, SALE OR SUPPLYING OF PRODUCTS, EVEN IF
BOGEN HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSSES. Some States do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specic legal rights,
and you may also have other rights which vary from State to State.
Products that are out of warranty will also be repaired by the Bogen Factory Service Department– same address as above or call 201-934-8500.
Returned products which do not qualify for warranty service, may be repaired or replaced at Bogen’s option with previously repaired or refur-
bished items. The parts and labor involved in these repairs are warranted for 90 days when repaired by the Bogen Factory Service Department.
All parts and labor charges as well as shipping charges will be at the owner’s expense.
All returns require a Return Authorization number. For most efcient warranty or repair service, please include a description of the failure.
10/2018
Limited Warranty: Exclusion of Certain Damages