BOLDLY GROWING BGRBD30 User manual

Step 2 Step 3
Start the base frame by taking one of the
Part A pieces (holes do not go through end
piece) and setting it with the holes facing
up as shown. Add a Part B piece as shown
and insert the Pin (C) to hold it in place.
Unfold the fabric liner (E) and locate the
two cutouts on each of the long sides. Take
one Drag Beam (D) and insert the end of it
through the bottom cutout of the fabric.
Line it up on the hole of the Part A piece
and insert Pin C as shown. Repeat for the
other side, being sure to slot the Drag
Beam (D) through the bottom cutout of the
fabric.
Take another Part A piece, fit it under the
open end of the Part B piece, and slide the
Pin (C) in as shown.
Step 1
A
B
A
BB
CC
E
C
A
(A) - 6pcs Pin (C) - 6pcs(B) - 6pcs Drag Beam (D) - 2pcs Fabric Liner
(E) - 1pcs
Thank you
Thank you and we hope you enjoy yourplanter bed! We truly believe people should be
outside and we hope this planter bed helps you do that.
Wooden Raised Planter Bed (BGRBD30)
Assembly Guide
We recommend positioning your raised bed on a level surface for best
results and to avoid gaps where the wood panels come together. If
needed, you can dig out the ground on the high spots to properly level
the planter.
Tip
If you have any problems with yourproduct orquestions during
assembly, please reach out to [e-mail] before
returningit to your place of purchase.
Need Help?
Assembly Instructions
Box Contents
Holes do
not go
through
end piece
Holes go
through
end piece Top cutout
Bottom
cutout

Step 7
Step 6
Fit a Part A piece (holes do not go through
end piece) under the open ends of the
Part B pieces and slide the last two Pins
(C) into place as shown.
Line up a Part B piece (holes go through
end piece) and slide it over the Pin (C) as
shown. Repeat for the other side.
Take two Part B pieces, placing them in
the locations as shown above, ensuring
they slot through the pins.
Take the second Drag Beam (D) and insert
the end of it through the top cutout of the
fabric. Slot it over a middle pin as shown.
Repeat for the other side, being sure to slot
the Drag Beam (D) through the top cutout
of the fabric before placing it over the pin.
Line up a Part B piece over the end pins
and slide into place as shown.
Step 4 Step 5
Step 9
Step 10
Step 8
Line up the final three Part A pieces and
slide into place as shown. Note: There
should be no visible pins or holes showing
at the end of the assembly.
Spread the fabric liner outwards to cover
as much area as possible.
B
A
C
C
B
B
B
DA
A
A
B
Will you share a photo of your new raised bed? Just post a photo on Facebook and type @boldlygrowing to tag us,
or share on Instagram and type #boldlygrowing in your post – we love seeing these posts!
Wooden Raised Planter Bed (BGRBD30)
Assembly Guide
Assembly Instructions (continued)