Bond CYPRESS 26 User manual

WARNING
WARNING
Do not store or use gasoline or other
vicinity of this or any other appliance.
For outdoor use only.
Owner’s Manual
CYPRESS 26" FIRE TABLE-WOOD
Item# 50460
Save these instructions for future use. If
you are assembling this unit for someone
else, give this manual to him or her and
read and save for the future.
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Read the owner’s manual thoroughly before installing or servicing this
result causing property damage, personal injury or loss of life.

Bond Manufacturing Company | Page 2
WARNING
Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so
SAFETY INFORMATION
•FOR OUTDOOR USE ONLY!
•
used in a building, garage, or any other enclosed area.
•
poker to remove and replace the lid.
•
Excessive heat may damage the integrity of the structure. The ONLY method of lighting used should be
•
•DANGER! DO NOT use the unit indoors due to hazard of carbon monoxide fumes. Lack of ventilation
can cause serious injury or death.
•
•
•
•
•
•
•
•
•
•
serious injury.
•
•Any guard or other protective device removed for servicing must be replaced prior to operating the
•
•
•Use with extreme care and at your own risk.
•
•
•
Do not move it while in operation.
•
•
•
•Users should be alerted to the hazards of high surface temperatures and keep a safe distance to
avoid burning or clothing ignition.
•
unit.
•Keep any electrical supply cords and the fuel supply hose away from any heated surfaces.
Lid knob Lid knob.

1-866-771-2663 | Page 3
•
•
•decks.

Bond Manufacturing Company | Page 4
AA BB
Item Description Qty
AA
BB
M4x8 Screw 1
M4 Washer 1
HARDWARE
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any parts are missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time: 5 minutes
Tools required for assembly (not included): Phillips Screwdriver

1-866-771-2663 | Page 5
Item Description Qty
AKnob 1
BLid 1
CLog rack 1
DFirebowl 1
EFire Poker 1
CONTENTSCONTENTS
A
B
C
D
E

Bond Manufacturing Company | Page 6
ASSEMBLY INSTRUCTIONS
1. Use M4x8 screw (AA) and M4 washer (BB)
to attach the knob ( A）to the lid (B).
2.
and cover the lid.
A
BBB
AA
B
C
D
log rock

To Light
To Extinguish
Tending The Fire
1.
2.
3. Place above that a layer of dry seasoned hardwood that is cut to lengths no more than 3/4 the
4. Use a long match to light kindling.
1.
2.
1.
2. Wait until glowing coals have developed before adding any additional wood. If additional wood is
required, place wood on top of coals. Be careful not to shift ashes.
3.
OPERATION
•
product life.
•Check handles to make sure they are secure.
•Check components for any signs of damage or rust.
•Wipe exterior surfaces with a mild cleaning product and water.
•For stubborn surfaces use a citrus based degreaser and soft cloth.
•Rinse surfaces clean of any cleaning product with water after cleaning is complete.
•Remove built-up creosote from components with a chimney cleaning product.
•
•Use manufacturer-approved or supplied replacement parts and accessories only. Otherwise it
may void the warranty of this product and result in a hazardous condition.
•
MAINTENANCE
E
E
fire pit
fire pit
fire pit
fire pit
fire pit
U
cover the lid.
1-866-771-2663 | Page 7

WARRANTY
If you have any questions or concerns, please contact Bond Manufacturing Company at the below
resources:
CONTACT
Toll Free Phone [phone]-BOND (2663) | Monday - Friday, 8am - 4:30pm PST
Email customer[email protected]
Online www.bondmfg.com
The manufacturer warranty will be voided by, and manufacturer disclaims any responsibility for, the
following actions:
•
•Use of any component part not manufactured or approved by Bond Manufacturing.
•Use and installation other than what is listed in this manual.
Please contact the manufacturer for replacement parts.
Bond Manufacturing Company | Page 8