BONTEC FN-411 Quick start guide

TV CARTS STANDS
FN-411
Component Checklist
A B C
6
5
M-A
M4x30
x4pcs
M-B
M6x15
x4pcs
M-C
M6x30
x4pcs
M-D
M8x20
x4pcs
M-E
M8x50
x4pcs
M-F
15x8x5
x8pcs
M-G
15x8x10
x8pcs
M-H
Washer
x4pcs
D E F G
M8x60
x8pcs
M8
x12pcs
M8x25
x4pcs
D8x16x1
x8pcs
S=6mm
x1pcs
STEP 1 Install the support foot and caster on the base.
M8x60
x4pcs
S=13mm
x1pcs
1
7 8 9 10
x2pcs x4pcs x1pcs
11
x1pcs x1pcs x1pcs x1pcs
1 2 3 4
x1pcs x2pcs
M6x10
x4pcs
3
A
x8pcs
4
STEP 2 Install the column on the base.
5
C
x2pcs
1
2
B
STEP 3 Install the DVD tray bracket on the post.
6
7
C
x2pcs
8
D
G
G
G

M-A/B/C/D/E
STEP 4 Adjust the inner column to the appropriate height.
Height
Adjustable
STEP 6 Mounting the Monitor Brackets to a TV.
First of all, Once you have determined the correct diameter,please see the diagram as below.
You will thread the Bolt into the TV using the correct Washer, and using thespacer if necessary.
Please make sure the Monitor Brackets are vertically centered and level with each other.
M-H
M-F/G/No
STEP 7 Attaching TV To TV Plate and Managing the Wires.
UNPACKING INSTRUCTIONS
! Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.
! Check package contents against the Supplied Parts List in the next page to assure that all components were received
undamaged. Do not use damaged or defective parts.
! Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before beginning the installation, and carefully
follow all instructions contained herein. Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
! If you don't understand these directions or have any doubts about the safety of the installation.
! If you are uncertain about the nature of your wall, consult a qualified installation contractor.
Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby
disclaim any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of
this product.
!!
2
Height
Adjustable
Press Hard.
STEP 5 Install the TV board on the column.
9
F E
F
B
10
11
The adjusting
handle is on the
outside.
Lock the safety screw.
!!
Multiplayer cooperation.
Height
Adjustable
x4pcs
Above the TV
G