BONTEC ST 13 User manual

1
 
      
 
 
!Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.
!Check package contents against the Supplied Parts List in the next page to assure that all components were received
undamaged. Do not use damaged or defective parts.
!Carefully read all instructions before attempting installation.
  
Install and operate this device with care. Please read this instruction before beginning the installation, and carefully
follow all instructions contained herein. Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
!If you don't understand these directions or have any doubts about the safety of the installation.
!If you are uncertain about the nature of your wall, consult a qualified installation contractor.
Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby
disclaim any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of
this product.

2
  
(4)M4x6 Bolt-z
(1)Metal Pad-f1
(4)M4x12 Bolt-l
(8)Metal Washer-h1
M6X10
(2)Metal Washer-h2
Ø6.5 * Ø18 * 2.0
(1)TV Plate-a2
(1)Secuity Wire Kit-x
(4)M8x35 Bolt-p
(4)M8 Washer-t
(4)M4x30 Bolt-m
(3)M8x22 Bolt-i
(2)Monitor Bracket-b
(2)Buckle-y
(4)M8x45 Bolt-q
(4)M4 Spacer-u
(1)Plastic Socket-e
(4)Rubber Foot-k
(10)M6x10 Bolt-g
(2)TV Plate-a1
(1)Allen Key-w
(4)M6x35 Bolt-o
(4)M6 Washer-s
(1)Support Column-d1 (1)Support Column-d2
(4)M6x20 Bolt-n
(2)Wire Clip-j
(1)Tempered Glass-c
(4)M4 Washer-r
(8)M6/M8 Spacer-v
(1)Soft Pad-f2
(1)Bubble Level

3
      
 
c
f2
f1
k
d1
d2
e
i
f
w




g
d2 d1
h2

4
      
 



wgh1
a2
a1
a1
gh1
Height
Adjustable
*TV Plate(a) can be installed on wall optionally,
wall mounting hardware have not included.

5
      
        
 
 




l to q
r,s,t
u,v
yz
Hang the TV onto Stand, there are two gears
that can be adjusted!
First of all, make sure the diameter of the Bolt(l to q) your TV requires. Once you have determined the correct diameter,
please see the diagram as below. You will thread the Bolt into the TV using the correct Washer(r,s,t), and using the
spacer(u,v) if necessary. Please make sure the Monitor Brackets are vertically centered and level with each other.

6
50mm
8mm
45mm
3.8mm
Wood Stud Wall
Concrete & Brick Wall
Diagram 5a Diagram 5b
Diagram 5e
Wall
Diagram 5c
Diagram 5d
       
 
If your TV is located nearby the wall as the Diagram 5a, then a steel wire can be attached for added security. Attaching
the two ends of steel wire to the top two holes on the back of TV, shown in Diagram 5b.
Attaching the another end of steel wire to the wall according to your wall type, shown in Diagram 5c, 5d and 5e.