boRn BN-HS168 User manual

boRn125KHzCurved-BarReaderOperationManual Version1.0
Model：BN-HS168
General
This is a 125KHz flash reader. When a 125KHz card is being read by the reader, the reader will lit up.
Reader Start up
When reader power up, the reader will lit ON. The Blue LED will maintain ON to show the power is ON. The
reader will ‘beep’to indicate the start up procedures is finished.
Installation Diagram
1. The back part shall fit on the wall.
2. The cover shall clip on the upper edge of the back part first.
3. After, tighten the screw goes underneath of the reader to fix the reader with the back part.
4. Propose to contact with 22AWG Shielding wire
Operating Specification:
Operating Voltage 9 ~ 13VDC Typical read range 5cm
Operating current 130mA Standard Color Black
Operating Temperature -20°C ~ 60°C Exterior dimension 150mm × 53mm × 25mm

boRn 125KHz Curved-Bar Reader Operation Manual Version 1.0
Function Description
Wiring Connection Table
Color Label Description
Red +12Vdc Power Supply to the reader
Black GND Signal GND
Green Data0 Wiegand Output data, D0
White Data1 Wiegand Output data, D1
Yellow Yellow LED No use
Blue Green LED Green LED control, active low
Brown Buzzer Can be control by outside device, active low
Grey Tamper Tamper output (open collector, Active low: 0Vdc Alarm output)
Physical Dimension