Bosch SPV40C10GB User manual

Operating Instructions - Dishwasher Bosch SPV40C10GB
Control Panel
1. ON/OFF switch
2. Timer programming*
3. Additional options**
4. Programme**
5. Button <
6. Button >
7. Cleaning display
8. Dry display
9. START button
10. Rinse aid refill indicator
11. Salt refill indicator
12. Display “Check water supply”
*Depending on model
**Number depending on model
Switching on the appliance
1. Switch the ON/OFF switch
2. Press the programme selector to the required programme. The expected programme duration flashes on the
digital display.
3. Press START button. The programme starts running.
End of programme
The programme has ended when the value 0:00 is indicated on the numerical display. The programme has ended
when neither of the two displays [8] or [7] is lit. The end of the programme is also indicated by an acoustic signal.
At the end of the programme please open the door fully and not partially when emptying the dishwasher. Remove
the utensils when they have cooled down.

Interrupting the programme
•Switch off ON/OFF switch, the LEDs go out. The programme is saved.
•If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar
for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring
open or water to run out of the appliance.
•To continue the programme, switch on the ON/OFF switch again.
Terminating the programme (Reset)
•Open the door.
•Press START button [9] for approx. 3 sec. until all displays go out.
•Close the door. The remaining programme sequence for draining the residual water takes approx. 1 minute.