Bosch Dinion XF LTC 0495/61 User manual

CCTV | LTC 0495 Series DinionXF Day Night Cameras
The LTC 0495 High Performance 1/3-inch Digital CCD Day/
Night Camera ensures the highest image quality possible at
any time. Depending on the available light the camera will
automatically switch from color to monochrome.
A unique combination of 15-bit digital video processing that
enhances sensitivity and XF-Dynamic which extends the
dynamic range provides a sharper, more detailed image
with outstanding accuracy in color reproduction.
All Dinion cameras are supplied ready to operate. Simply
attach and focus the lens, then connect power. No tools are
required for back focus and power connection. For
especially challenging situations where fine tuning or
special settings are required, the camera parameters can be
individually set using the control buttons on the side of the
camera and On-screen Display (OSD). The camera
automatically detects the lens type. The Lens Wizard
ensures accurate back-focusing for perfectly sharp pictures
at all times.
Functions
XF-Dynamic
The highly accurate 15-bit digital signal is automatically
processed to optimally capture the detail in both the high
and low light areas of the scene simultaneously, maximizing
the information visible in the picture.
Bilinx Technology
Bilinx is a bidirectional communication capability
embedded in the video signal of all Bosch Dinion cameras.
Technicians can check status, change camera settings and
even update firmware from virtually anywhere along the
video cable. Bilinx reduces service and installation time,
provides for more accurate set-up and adjustment, and
improves overall performance. In addition, Bilinx uses the
standard video cable to transmit alarm and status
messages, providing superior performance without
additional installation steps.
Video Motion Detection
The built-in video motion detector allows you to select up
to four fully programmable areas with individual thresholds.
The global scene change detector minimizes false alarms
caused by sudden lighting condition changes, such as
switching on or off the indoor or security lighting. When
motion is detected alarms may be displayed in the video
signal while the output relay can be closed in addition to
alarm message transmission on Bilinx.
Auto Black
The automatic black level feature enhances contrast by
compensating for reduced contrast (i.e. glare, fog, mist).
LTC 0495 Series DinionXF Day Night
Cameras
▶15-bit DSP Technology
▶High sensitivity
▶Mechanically switching IR filter for IR sensitivity at
night
▶XF-Dynamic for unsurpassed wide dynamic range
▶Bilinx Communication for remote set-up and control
▶Default Shutter eliminates motion blurring
▶Four area video motion detection
▶540 TVL resolution
www.boschsecurity.com

2 | LTC 0495 Series DinionXF Day Night Cameras
Default Shutter
The LTC 0495 features a fast, default shutter speed in
sufficient lighting conditions to capture moving objects.
When light levels fall and other adjustments have been
exhausted, the shutter speed reverts to the standard
setting to maintain sensitivity.
Back Light Compensation (BLC)
Offering a fully programmable BLC area of interest, and a
variable BLC level, the camera can be easily set up for even
the most challenging entrance applications.
Lens Wizard
The Lens Wizard automatically detects the lens type and
helps focus the lens at the maximum opening to ensure
proper focus is maintained throughout the 24-hour cyle. No
special tools or filters are required.
Programmable Modes
Three independent, preprogrammed operating modes
support typical applications, but are fully programmable for
individual situations. Switching between modes is easy via
Bilinx or the external alarm input.
Day/Night Mode
The Day/Night Mode LTC 0495 provides enhanced night
viewing by increasing the IR sensitivity. The IR filter can
switch from color to monochrome automatically by either
sensing the illumination level or via the alarm input. The
filter can be switched manually via the alarm input, through
the camera menu or via the Bilinx coaxial control interface.
An internal through the lens IR detector enhances the
monochrome mode stability, as it prevents reverting to the
color mode when IR illumination is dominant.
SensUp
By increasing the integration time on the CCD up to 10
times, the effective sensitivity is dramatically enhanced.
This is especially useful when relying only on moonlight for
illumination.
Certifications and Approvals
Electro Magnetic Compatibility
Emission EN55022 class B, FCC class B part 15
Immunity EN50130-4 Alarm Systems, Part 4
Vibration Camera with 500 gr (1.1 lbs) lens according
to IEC60068-2-27
Safety
LTC 0495/11 and LTC 0495/51: EN60065
LTC 0495/21 and LTC 0495/61: UL6500, cUL CAN/CSA E60065-00
Installation/Configuration Notes
Dimensions in mm (inches)
Parts Included
Quantity Component
1LTC 0495 Series DinionXF Day\Night Camera
1 C/CS – mount conversion ring
1 Spare male 4 – pin lens connector
Lens not included
Technical Specifications
Electrical
Model No. Rated Voltage
LTC 0495/11 12 – 28 VAC 45 - 65 Hz
11 – 36 VDC
LTC 0495/21 12 – 28 VAC 45 - 65 Hz
11 – 36 VDC
LTC 0495/51 110 – 240 VAC 45 - 65 Hz
LTC 0495/61 110 – 240 VAC 45 - 65 Hz
Power Consumption 4 W
CCD Type 1/3-inch interline
Active Pixels
PAL Model: 752 x 582
NTSC Model 768 x 492
Sensitivity (3200 k)
Sensitivity (full video) 1) 2.4 lux (0.24 fc)
Sensitivity 50 IRE1) 0.59 lux / 0.08 lux (Monochrome mode)
Minimum illumination1) 0.24 lux / 0.038 lux (Monochrome mode)
Minimum Illumination with
Sens Up
0.024 lux / 0.0038 lux (Monochrome mode)

LTC 0495 Series DinionXF Day Night Cameras | 3
Horizontal Resolution 540 TVL
Signal-to-Noise Ratio > 50 dB
Video Output 1 Vpp, 75 ohm
Y/C Output Y: 1 Vpp / C: 0.3 Vpp
Synchronization Internal, Line Lock, HV-lock and Genlock (Burst
lock) selectable
Shutter Auto (1/60 (1/50) to 1/500000), fixed, flick-
erless, default
Sensitivity up Off, Automatic continuous up to 10x
Auto Black On, Off selectable
Range 32x dynamic range enhancement
Dynamic Noise Reduction Auto, Off selectable
Contour Sharpness enhancement level selectable
BLC Off, Area and Level selectable
Gain Auto (maximum level selectable to 28 dB) or
fixed level selectable
Lens Mount CS (max lens protrusion 5 mm, 0.2 inch)
White Balance ATW (2500 - 10000 K), AWB hold, Manual WB
selectable
VMD 4 area, sensitivity selectable
Alarm Output VMD or Bilinx
Alarm Input (TTL) Profile switching, +5 V nominal, +40 VDC max
Alarm Output Relay max. 30 VAC or +40 VDC, Max 0,5 A continu-
ous, 10 VA
External Synchronal Input 75 ohm or High Impedance selectable
Cable Compensation Up to 1000 m (3000 ft) coax without external
amplifiers (automatic set-up in combination
with coaxial communication)
Camera ID 16 character editable string, position selecta-
ble
Lens Types Manual, DC- and Video-Iris auto-detect with
override DC-iris drive: max. 50 mA continuous
Video-iris: 11.5 ± 0.5 VDC, max 50 mA con-
tinuous
Remote Control Bilinx coaxial communication
1) F/1.2, 89% reflection, SenseUp off
Mechanical
Dimensions (H x W x L) 59 x 67 x 122 mm (2.28 x 2.6 x 4.8 inch) with-
out lens
Weight 450 g (0.99 lbs) without lens
Tripod Mount Bottom (isolated) and top 1/4-inch 20 UNC
Controls OSD with softkey operation
Environmental
Operating Temperature -20°C to +50°C (-4°F to 122°F)
Storage Temperature -25°C to +70°C (-13°F to +158°F)
Operating Humidity 20% to 93% RH
Storage Humidity up to 98% RH
Ordering Information
LTC 0495/11 DinionXF Day Night Camera
1/3-inch, high performance, 540 TVL, PAL,
DSP, 12 – 28 VAC/11 – 36 VDC, 50 Hz
LTC0495/11
LTC 0495/21 DinionXF Day Night Camera
1/3-inch, high performance, 540 TVL, NTSC,
DSP, 12 – 28 VAC/11 – 36 VDC, 60 Hz
LTC0495/21
LTC 0495/51 DinionXF Day Night Camera
1/3-inch, high performance, 540 TVL, PAL,
DSP, 110 – 240 VAC, 50 Hz
LTC0495/51
LTC 0495/61 DinionXF Day Night Camera
1/3-inch, high performance, 540 TVL, NTSC,
DSP, 12 – 28 VAC, 60 Hz
LTC0495/61
Accessories
LTC 3364/21 Varifocal Lens IR corrected
1/3-inch, 2.8 – 6 mm, DC-iris, CS-mount
F1.4-200, 4-pin
LTC3364/21
LTC 3764/20 Varifocal Lens IR corrected
1/2-inch, 4 –12 mm, DC-iris, C-mount,
F1.2-360, 4-pin
LTC3764/20
LTC 3774/30 Varifocal Lens IR corrected
1/2-inch, 10 – 40 mm, DC-iris, C-mount,
F1.4-360, 4-pin
LTC3774/30
LTC 3783/50 Zoom Lens IR corrected
1/2-inch, 8.5 – 85 mm, Video-iris, C-mount
F1.6-360, 4-pin
LTC3783/50
LTC 3793/50 Zoom Lens IR corrected
1/2-inch, 8 – 144 mm, Video-iris, C-mount,
F1.6-360, 4-pin
LTC3793/50
LTC 3664/40 Varifocal Lens IR corrected
1/3-inch, 2.8 – 11 mm, DC-iris, CS-mount
F1.4-360, 4-pin
LTC3664/40
LTC 3664/30 Varifocal Lens IR corrected
1/3-inch, 3.0 – 8 mm, DC-iris, CS-mount
F1.0-360, 4-pin
LTC3664/30
TC 120PS Power Supply Unit
110-120 VAC/15 VDC, 50/60 Hz, 300 mA
TC120PS
TC 220PS Power Supply Unit
230 VAC/12 VDC, 50 Hz, 10 VA
TC220PS
TC 220PSX‑24 Power Supply Unit
230 VAC/20 VAC, 50 Hz, 20 VA
TC220PSX-24
TC 1334 Power Supply Unit
120 VAC/24 VAC, 60 Hz, 30 VA
TC1334
Software Options
VP‑CFGSFT Configuration Software
for cameras using Bilinx, includes VP-USB
Adaptor
VP-CFGSFT
www.boschsecurity.com

4 | LTC 0495 Series DinionXF Day Night Cameras
Americas:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.us
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: [phone]
[email protected]
www.boschsecurity.com
Asia-Pacific:
Bosch Security Systems Pte Ltd
38C Jalan Pemimpin
Singapore 577180
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.com
Represented by
© Bosch Security Systems Inc. 2008 | Data subject to change without notice
T1892146827 | Cur: en-US, V7, 7 Jul 2008