Bosch FLEXIDOME NIN-733 User manual

FLEXIDOME HD VR
NIN-733 / NIN-832 / NIN-932
en Installation Manual

FLEXIDOME HD VR Table of Contents | en 3
Bosch Security Systems Installation Manual AM18-Q0637 | v1.1 | 2013.08
Table of Contents
1Safety 6
1.1 Safety precautions 6
1.2 Important safety instructions 7
1.3 Connection in applications 8
1.4 Type label 8
1.5 FCC & ICES compliance 9
1.6 MicroSD cards 10
1.7 UL certification 10
1.8 Bosch notices 11
1.9 Copyrights 12
2 Introduction 13
2.1 Features 13
3 System Information 14
3.1 Network video server 14
3.1.1 Progressive scan 14
3.1.2 True Day/Night function 14
3.1.3 Multiple streams 14
3.1.4 ONVIF (Open Network Video Interface Forum) 14
3.1.5 Audio 15
3.1.6 Alarm I/O 15
3.1.7 Tamper detection and motion detection 15
3.1.8 Video encoding 15
3.1.9 Multicast 15
3.1.10 Power-over-Ethernet 15
3.1.11 Encryption 15
3.1.12 Recording 16
3.1.13 Configuration 16
3.2 Operation with external systems 17
4 Planning 18
4.1 Unpacking 18
4.2 System requirements 18

4en | Table of Contents FLEXIDOME HD VR
AM18-Q0637 | v1.1 | 2013.08 Installation Manual Bosch Security Systems
5 Installation 19
5.1 Parts 19
5.2 Mounting the unit 20
5.2.1 Surface mounting 20
5.2.2 Flush mount 21
5.3 Connections 22
5.3.1 Make the connections 22
5.4 Mount the camera 25
5.5 Controls 26
5.6 Camera positioning and field-of-view 27
5.6.1 Pan 28
5.6.2 Tilt 28
5.6.3 Twist 29
5.7 Using the install wizard 30
5.7.1 Adjustment procedure 30
5.8 Closing the unit 31
6 Camera configuration 33
6.1 User modes 33
6.2 Day/Night switching 33
7 Browser connection 34
7.1 Protected network 34
8Troubleshooting 35
8.1 Function test 35
8.2 Resolving problems 36
8.3 Customer service 38
9 Maintenance 39
9.1 Testing the network connection 39
9.2 Cleaning the bubble 39
9.3 Repairs 40
9.3.1 Transfer and disposal 40
10 Technical Data 41
10.1 Specifications 41

FLEXIDOME HD VR Table of Contents | en 5
Bosch Security Systems Installation Manual AM18-Q0637 | v1.1 | 2013.08
10.1.1 Dimensions 47

6en | Safety FLEXIDOME HD VR
AM18-Q0637 | v1.1 | 2013.08 Installation Manual Bosch Security Systems
1Safety
1.1 Safety precautions
DANGER!
High risk: This symbol indicates an imminently hazardous
situation such as "Dangerous Voltage" inside the product.
If not avoided, this will result in an electrical shock, serious
bodily injury, or death.
WARNING!
Medium risk: Indicates a potentially hazardous situation.
If not avoided, this could result in minor or moderate bodily
injury.
CAUTION!
Low risk: Indicates a potentially hazardous situation.
If not avoided, this could result in property damage or risk of
damage to the unit.
CAUTION!
The Low Voltage power supply unit must comply with EN/UL
60950. The power supply must be a SELV-LPS unit or a SELV -
Class 2 unit (Safety Extra Low Voltage - Limited Power Source).
CAUTION!
The camera must be connected to earth.

FLEXIDOME HD VR Safety | en 7
Bosch Security Systems Installation Manual AM18-Q0637 | v1.1 | 2013.08
1.2 Important safety instructions
Read, follow, and retain for future reference all of the following
safety instructions. Follow all warnings on the unit and in the
operating instructions before operating the unit.
1. Clean only with a dry cloth. Do not use liquid cleaners or
aerosol cleaners.
2. Do not install unit near any heat sources such as radiators,
heaters, stoves, or other equipment that produce heat.
Avoid exposure to direct sunlight for long periods.
3. Never spill liquid of any kind on the unit.
4. Take precautions to protect the unit from power and
lightning surges.
5. Adjust only those controls specified in the operating
instructions.
6. Operate the unit only from the type of power source
indicated on the label.
7. Unless qualified, do not attempt to service a damaged unit
yourself. Refer all servicing to qualified service personnel.
8. Install in accordance with the manufacturer's instructions
in accordance with applicable local codes. Use only
attachments/accessories specified by the manufacturer.
Equipment change or modification could void the user's
guarantee or authorization agreement.
9. Connect the yellow/green earth wire of the camera to the
system earth of the installation to ensure correct safety
and EMC/RFI protection.

8en | Safety FLEXIDOME HD VR
AM18-Q0637 | v1.1 | 2013.08 Installation Manual Bosch Security Systems
1.3 Connection in applications
Grounding
The yellow/green safety (power) ground wire from the camera
must be connected to the system earth of the installation.
U.S.A.: - section 810 of the National Electrical Code, ANSI/NFPA
No.70, provides information regarding proper grounding.
12 VDC / 24 VAC power source: This unit is intended to
operate with a limited power source. The unit is intended to
operate at either 12 VDC or 24 VAC (if PoE is not available).
User supplied wiring must be in compliance with electrical
codes (Class 2 power levels).
PoE: Use only certified PoE devices. Power-over-Ethernet can
be connected at the same time as a 12 VDC or 24 VAC power
supply.
If auxiliary power (12 VDC or 24 VAC) and PoE are applied
simultaneously, the camera selects auxiliary input and shuts off
the PoE.
1.4 Type label
The type label is located on the side of the camera module.

FLEXIDOME HD VR Safety | en 9
Bosch Security Systems Installation Manual AM18-Q0637 | v1.1 | 2013.08
1.5 FCC & ICES compliance
FCC & ICES Information
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
– reorient or relocate the receiving antenna;
– increase the separation between the equipment and
receiver;
– connect the equipment into an outlet on a circuit different
from that to which the receiver is connected;
– consult the dealer or an experienced radio/TV technician
for help.
Intentional or unintentional modifications, not expressly
approved by the party responsible for compliance, shall not be
made. Any such modifications could void the user's authority to
operate the equipment. If necessary, the user should consult
the dealer or an experienced radio/television technician for
corrective action.
The user may find the following booklet, prepared by the
Federal Communications Commission, helpful: "How to Identify
and Resolve Radio-TV Interference Problems". This booklet is
available from the U.S. Government Printing Office,
Washington, DC 20402, Stock No. 004-000-00345-4.

10 en | Safety FLEXIDOME HD VR
AM18-Q0637 | v1.1 | 2013.08 Installation Manual Bosch Security Systems
1.6 MicroSD cards
Bosch Security systems recommends that local storage on
microSD card should only be used for alarm recording and
Automatic Network Replenishment (ANR) applications. To
minimize the risk of loss of digital information, we recommend
multiple, redundant recording systems, and a procedure to
back up all digital information.
1.7 UL certification
Disclaimer
Underwriter Laboratories Inc. ("UL") has not tested the
performance or reliability of the security or signaling aspects of
this product. UL has only tested fire, shock and/or casualty
hazards as outlined in UL's Standard(s) for Safety for Information
Technology Equipment, UL 60950-1. UL Certification does not
cover the performance or reliability of the security or signaling
aspects of this product.
UL MAKES NO REPRESENTATIONS, WARRANTIES, OR
CERTIFICATIONS WHATSOEVER REGARDING THE
PERFORMANCE OR RELIABILITY OF ANY SECURITY OR
SIGNALING RELATED FUNCTIONS OF THIS PRODUCT.
Disposal - Your Bosch product was developed and
manufactured with high-quality material and components that
can be recycled and reused. This symbol means that
electronic and electrical appliances, which have reached the
end of their working life, must be collected and disposed of
separately from household waste material. Separate collecting
systems are usually in place for disused electronic and
electrical products. Please dispose of these units at an
environmentally compatible recycling facility, per European
Directive 2002/96/EC