Bose SoundDock AM316536 User manual

SOUNDDOCK®10
DIGITAL MUSIC SYSTEM
Bluetooth®Dock
Owner’s Guide

2
English
Safety information
Please read this owner’s guide
Please take the time to follow the instructions in this owner’s guide carefully. It will help you
set up and operate your system properly and enjoy its advanced features. Please save this
owner’s guide for future reference.
WARNINGS:
• To reduce the risk of fire or electrical shock, do not expose the product to rain or moisture.
• Do not expose this apparatus to dripping or splashing, and do not place objects filled with
liquids, such as vases, on or near the apparatus. As with any electronic products, use care
not to spill liquids into any part of the system. Liquids can cause a failure and/or a fire haz-
ard.
• Do not place any naked flame sources, such as lighted candles, on or near the apparatus.
• Contains small parts which may be a choking hazard. Not suitable for children under age 3.
Notes:
• This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations (Canada only).
• If applicable, the radio communication device incorporated into this apparatus meets all
requirements of the Industry Canada standard RSS-310 (Canada only).
• The product must be used indoors. It is neither designed nor tested for use outdoors, in rec-
reation vehicles, or on boats.
This product conforms to the EMC Directive 2004/108/EC and to the Low Voltage
Directive 2006/95/EC. The complete Declaration of Conformity can be found at
www.Bose.com/static/compliance/index.html.

3
English
Compliance with FCC rules (U.S.A. only)
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part15 of the FCC rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communica-
tions. However, this is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, you are encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit than the one to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING
• Changes or modifications not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate this equipment.
• Proper connections must be used for connection to a host computer and/or peripherals
in order to meet FCC emission limits.

4
English
Overview
The Bose®SoundDock®10 Bluetooth®dock adds Bluetooth wireless
technology capability to your SoundDock®10 digital music system.
After installing this accessory, you can listen to your stereo Bluetooth
music phone with high-quality, room-filling sound.
To experience the intended performance, your stereo Bluetooth music
phone must support the Bluetooth Advanced Audio Distribution Profile
(A2DP).
Installing the Bluetooth dock
1. Disconnect the SoundDock 10 power cord from the AC outlet.
2. Lift up the back edge of the universal dock adapter (A) and remove it
from the dock. You may need to insert a thin non-metallic utensil into
the slot to provide the required leverage to lift the back edge.
3. Press the dock release button (B) on the right and lift up (C) the right
side of the dock to remove it.
ABC

5
English
4. Slide the left end of the Bluetooth®dock into the dock opening (A).
5. Press down on the right side of the dock until it locks in place (B).
Making the first connection
1. Plug the power cord of the SoundDock®10 digital music system into
an AC receptacle.
2. Wait until the Bluetooth®light starts flashing, meaning that the Blue-
tooth®dock is in discoverable mode.
NOTE: The dock stays in discoverable mode (for as long as 30 minutes) until you con-
nect your stereo Bluetooth music phone to it.
AB
Bluetooth light
(flashing = discoverable mode)

6
English
3. Bring your stereo Bluetooth music phone close to the SoundDock 10
system.
4. Turn on the Bluetooth feature in your music phone. For details on
using this feature, refer to the owner’s guide for your phone.
5. In the list of found Bluetooth devices, find “Bose SoundDock 10” and
select it.
6. If prompted, enter the Bose SoundDock 10 passkey: 0000.
7. When your music phone confirms it is connected, check that the
Bluetooth light stops flashing and remains on.
If your stereo Bluetooth music phone becomes disconnected
because it is out of range, the dock automatically tries to reconnect with it
when you bring it within range again. If the SoundDock 10 system can not
restore a connection within five minutes it turns off.
To disconnect, press Off on the Bose®SoundDock 10 remote or use the
disconnect command in your phone.
To reconnect when your system is off, press any remote key except
Off or AUX to turn on the system. The SoundDock 10 system then auto-
matically tries to connect with the most recently-connected phone.

7
English
Connecting with other stereo Bluetooth music phones
After making an initial connection, you can change the connection to
another phone by activating the discoverable mode again. However, you
can connect to only one phone at a time.
1. Press and hold the Bluetooth®button on the dock or the dock button
on the remote control until the Bluetooth light starts flashing.
2. Follow Steps 3-7 on the previous page.
For the purpose of automatic reconnection, the SoundDock®10 system
remembers the six most recently-connected music phones.
Controlling the volume
Increase the volume of your stereo Bluetooth music phone to near
maximum. Then use the Bose SoundDock 10 remote to control the
system volume.
Bluetooth
button
Dock
button

8
English
Connection quality light
The quality of any wireless connection with the Bluetooth dock can vary.
This may affect the quality of the audio heard from your SoundDock 10
system.
The connection quality light on the dock
tells you the general condition of the
wireless connection made between your
phone and the Bluetooth dock:
• Constantly On .......No affect on audio
quality
• Blinking..................Audio quality may
be affected
• Blinking faster .......Audio quality is
most likely affected
If the audio quality is affected:
• Move your phone closer to the system or to a different location.
• Move your phone away from any household device that generates elec-
tromagnetic radiation, such as a microwave oven, another Bluetooth
device, or a wireless computer network router.
• Reduce the number of applications running on your phone.
Connection
quality light (On)

9
English
Troubleshooting
If you experience difficulty with your Bluetooth®dock, use the following
table to try and solve the problem. If the problem still persists, see “Con-
tacting customer service” on page 11.
Problem What to do
Can not
connect
my phone
to the
dock
• Make sure your SoundDock®10 is connected to AC power.
• Make sure the Bluetooth dock is in discoverable mode (Bluetooth
light is flashing). If not, press and hold the Bluetooth button on the
dock until the Bluetooth light starts flashing.
• Make sure the Bluetooth feature is turned on in your phone. For
details, refer to the owner’s guide for your phone.
• Move your phone closer to the SoundDock 10.
• Go to http://owners.bose.com on the Internet and find information on
updating your SoundDock 10.
No sound • Make sure the SoundDock 10 and your phone are turned on.
• Make sure you have a Bluetooth connection (Bluetooth light is on).
• Move your phone closer to the SoundDock 10.
• Turn up the phone volume as high as possible.
• Turn up the SoundDock 10 volume.
Sound is
dropping
out or
breaking
up
• Move your phone or SoundDock 10 away from any device that gen-
erates electromagnetic radiation, such another Bluetooth device, a
microwave oven, or a wireless computer network router.
• Remove any physical obstruction lying between your phone and the
SoundDock 10 system.
• Reposition your phone and or the SoundDock 10 system.

10
English
Removing the Bluetooth®dock
To remove t he Bluetooth dock so that you can put the universal dock back
in your system:
1. Slide the release latch (A) to the right.
2. Lift up the right side (B) of the Bluetooth dock to remove it.
Poor
sound
quality
• Move your phone closer to the system or to a different location.
• Move your phone away from any household device that generates
electromagnetic radiation, such as a microwave oven, another Blue-
tooth device, or a wireless computer network router.
• Reduce the number of applications running on your phone.
• Increase the volume on your phone.
Problem What to do
AB