Bosstab Elite Nexus User manual

www.bosstab.com
The Elite Nexus
1
Installation Guide
Rotate stand 45odegrees so cable hole is on the left,
and then screw in lock screw as shown. This will lock the
rotation for a xed option.
Unscrew existing closed cable cutout and install the
open cable cutout included with stand.
Wipe base of stand and your
mounting surface with alcohol
wipes provided and let dry.
Unlock case with keys provided
and remove faceplate.
Let the stand sit for 24 hours
before use.
Place faceplate back on and lock.
Follow steps 4-6 for adhesive
mount instructions
Stick 3M adhesive to the base of
stand and rmly place down on
your mounting surface.
Feed cable through the stand and
plug in your tablet while placing it
into the case.
4
1
5
2
6
3
Optional Position Lock
Freestanding & Adhesive Mount instructions
Optional Cable Through Channel

www.bosstab.com
The Elite Nexus
2
Follow the above locations to line
up your surface mounting and
cable feed.
Screw base holes
Cable feed hole
Installation Guide
Unlock case with keys provided
and remove faceplate.
Plug in your tablet while placing it
into the case.
Place faceplate back on and lock.
If you are running your charging
cable through the surface,
ensure to drill a larger hole to
feed cable through.
Remove screws from case and lift
the case o the stand.
Place case back on the stand and
screw back in the 4 screws.
With the cable channel facing out
the left hand side of the stand,
screw down your stand using the
wood screws provided.
4
1
7 8 9
5
2
6
3
Screw Mount instructions
We recommend drilling pilot holes
to assist with screw base mounting.