Thor’s Drone World Lifthor Mjolnir User manual

by Thor’s Drone World
User’s Manual

Congratulations
on your new
the Ultimate Tablet holder for
DJI Mavic Series

Aluminum body
Content:
Aluminum
ball joint
Tablet clamp
Compatible with 7.9” up to
13” devices
Support plate
Hex Key (x2)

How to assemble:
Remove the components from the box, use the bigger
hex key provided to unscrew the ball joint
Using the bigger Hex key
provided, secure the ball
joint on the top hole of
the aluminum body, make
sure it is tightened hard.

With the smaller hex key
provided, untighten the
aluminum stopper from
the underside of the body.

Slide the stopper all the way
to the back to allow space
for the RC to enter.
*Note:
The body has 2 anti-slip pads to
protect the RC from any scratches
and keep it secure in place.

Stopper

Prepare the RC by raising the antennas and
extracting the arms all the way out

Gently lower the RC into the bay of
the base with a slight inclination. You
might feel some resistance while
sliding the controller in place, due to
the anti-slip pads.

Secure the RC in place by sliding the
stopper towards the RC. Make sure
the RC is center and align properly

Once everything is in place, secure the
stopper from underneath the body,
with the small Hex Key provided.