Bosstab Fusion User manual

Fusion | Flex Arm
Installation Guide
Option A & B both continues to step 5.
Screw the other Mounting Bracket
to the opposite end of the Flex Arm
with A6 screws (4x).
Screw the Fusion case onto the
Mounting Bracket of the Flex Arm
with A1 screws & washer (4x).
Place the required Adapter Pads (G)
onto the matching slots in the case,
numbered 1-4.
Install the faceplate and lock with
the key provided (F).
Place the tablet into the case and
plug in the power cable.
Optional hex socket screw provided
for added security (D).
5
7
9
6
8
10
www.bosstab.com

Screw the Flex Arm onto the surface
from below with A5 screws (4x).
Skip to Step 5.
2a
1a
UNDER table mounting
OPTION A
Screw the Mounting Bracket onto the
surface with A2 or A3 screws (4x).
Slot in one Mounting Cover from the
opposite end of the Flex Arm as shown.
Slot in two Mounting Cover from the
opposite end of the Flex Arm as shown.
Feed a power cable through the Flex
Arm and into your pre-cut hole of
the mounting surface.
Screw one Mounting Bracket onto the
Flex Arm with A6 screws (4x).
Feed a power cable through the Flex
Arm either through a pre-cut hole or
for above counter solution as shown.
Flex Arm
1x
Mounting Cover
2x
Mounting Bracket
2x
A1
4x
A2
4x
A3
4x
A5
4x
A6
8x
D
1x
E
1x
F
2x
G
4x
2b
3b
1b
ABOVE table mounting
Cable belowCable above
OPTION B
4b4a
3a
Turnover page and continue to step 5. Turnover page and continue to step 5.