BOSTONtec CPU12 User manual

Under Work Surface CPU
Holders
1
Part # CPU12, CPU20 - Under Work Surface CPU Holder
#2 Phillips screwdriver
3/8” nut driver or wrench
Impact driver with #3 Phillips bit
Tool List
Item Components Qty
A #10-32 x ½” Phillips pan head machine screw 6
B #10-32 Kep nut 6
CCPU holder track mounng bracket 1
D CPU holder track 1
E #12 x ¾” Phillips pan head sheet metal screw 8
F CPU holder 1
G Quick track end cap 1
H Quick track pin 2
C
D
F
1Align the holes on CPU holder track (D) with the holes on CPU holder track mounng bracket (C) as
shown in Fig-1. Use six #10-32 x ½” Phillips pan head machine screws (A) and six #10-32 Kep nuts (B) to
connect CPU holder track mounng bracket (C) and CPU holder track (D).
A
D
Fig-1
C
B

Under Work Surface CPU
Holders
2
2Mount the CPU holder track mounng bracket (C) with CPU holder track (D) aached to the underside of
the work surface using eight #12 x ¾” Phillips pan head sheet metal screws (E) (Fig-2).
*Ensure rear tab stops on track are facing the back of the table (Fig-3)
Fig-2
Fig-3
E
D
C
D
Rear tab stops

Under Work Surface CPU
Holders
3
Height Lock
Mounng Rail Width Knob
Upper Assembly
Side Bracket
Base
G
D
H
H
H
D
Loosen Width Knob and slide
Side Bracket outward. Loosen
Height Lock and slide Upper
Assembly to highest posion.
Center CPU on the Base.
Lower Upper Assembly unl
it lightly touches top of CPU.
Tighten Height Lock. Push
Side Bracket inward unl
it ts ghtly against CPU.
Center Mounng Rails above
CPU. Tighten Width Knob.
Install CPU into the holder Install CPU holder (with CPU in it) into Track
Remove CPU from CPU Holder.
*It is important that you remove the CPU
holder with CPU in it from the CPU Holder
Track rst.
Align Mounng Rails of the CPU holder with
front edge of CPU Holder Track (D). Slide CPU
holder unit into Track.
Rotate Quick Track pins (H) 90 degrees.
Remove Quick Track End Cap (G) from CPU
Holder Track (D). Slide CPU holder (with CPU in
it) o the Track (D).
Loosen Width Knob and Height Lock of the
CPU holder. Remove CPU from holder.
Slide Quick Track End Cap
(G) into Track (D). Insert
Quick Track Pins (H) into
Quick Track End Cap (G)
(Fig-4), rotate them 90
degrees to lock (Fig-5).
aa
a
b
b
34
5
b
Fig-4
Fig-5