BOSTONtec UWKMS User manual

Under Work Surface
Keyboard Trays
1
Part # UWKMS - Under Work Surface Keyboard Tray with
Sliding Mouse Plaorm
Part # UWKMP - Under Work Surface Keyboard and Mouse Plaorm
#2 Phillips screwdriver
3/8” nut driver or wrench
Impact driver with #3 Phillips bit
Tool List
Item Components Qty
A#10-32 x ½” Phillips pan head machine screw 6
B #10-32 Kep nut 6
CKeyboard track mounng bracket 1
D Keyboard track 1
E#12 x ¾” Phillips pan head sheet metal screw 8
GKeyboard tray with sliding mouse plaorm
assembly 1
Item Components Qty
A#10-32 x ½” Phillips pan head machine screw 6
B #10-32 Kep nut 6
CKeyboard track mounng bracket 1
D Keyboard track 1
E#12 x ¾” Phillips pan head sheet metal screw 8
FKeyboard and mouse plaorm assembly 1
G
F

Under Work Surface
Keyboard Trays
2
1
2
3
Mount the keyboard track mounng bracket (C) with keyboard track (D) aached to the underside of
the work surface using eight #12 x ¾” Phillips pan head sheet metal screws (E). For opmal use, mount
the front of the bracket outside the front rail of the workstaon (Fig-3).
Refer to the manufacturer’s assembly instrucons on how to mount the keyboard tray with/without
mouse plaorm to the keyboard track (D).
Align the holes on keyboard track (D) with the holes on keyboard track mounng bracket (C) as shown
in Fig-1. These two pieces should be nearly ush on the end where the keyboard track rear tab stops
are located. Use six #10-32 x ½” Phillips pan head machine screws (A) and six #10-32 Kep nuts (B) to
connect keyboard track mounng bracket (C) and keyboard track (D) (Fig-2).
A
D
D
Fig-2
Fig-1
Fig-3
E
C
C
Rear Tab Stop
Rear Tab Stop
Front
Front
Front
Back
Back
Back
B
C