BOXLIGHT ProColor IFPD-MOB User manual

For using this product properly and safely, please follow the
contents of the Installation and Operation Manual to install.
It is suggested that this Electric Stand applies to the 55-75
inch intelligent panel.
This stand can carry a maximum weight of 100KG.

1
Accessories
Base (1pcs)
Lifting column (1pcs)
Wall Mount (1pcs)
Shelf(1pcs)
Hanging bar (2pcs)
Control pad (1pcs)
AC Power Cable (1pcs)
USB Cable(1pcs)
AC Power transfer Cable (1pcs)
A-Base(1pcs) B-Lifting column -(1pcs)
C-Wall Mount (1pcs)
D-Shelf(1pcs)
E- Hanging bar (2pcs)
F-Control pad (1pcs) G-AC Power Cable
(1pcs)
H-USB Cable
(1pcs)
I-AC Power transfer
Cable (1pcs)
①Hexagon socket
countersunk head screws
KM10*25
4pcs
②Cross recessed pocket
hexagon head screw
M8*20
4pcs
③Cross recessed pocket
hexagon head screw
M5*15
2pcs
④Cross recessed T-head
with collar screw
TM4*6
4pcs
⑤Plastic bolts
/
4pcs
⑥Hex nut
6mm
1pcs
⑦Cross recessed pocket
hexagon head screw
M8*25
4pcs
⑧Cross recessed pocket
hexagon head screw
M6*20
4pcs
⑨Cross screwdriver
(Self-Provided)
/
1pcs
⑩Monkey spanner
(Self-Provided)
/
1pcs

2
Step2: Connect the power cable between the lifting column B and the
base A, install the lifting column and tighten the screws (figure 2).
A
⑤
①
⑥
figure 2
Step1: The shelf D is fixed with the lifting column B (figure 1).
④
D
B
figure 1

3
4
Step4: Assemble the Interactive Flat Panel and hanging bar E with right
screw（⑦or ⑧）based on actual use demand. (figure 4).
K
Munting hole K
1
⑦or ⑧
K
8
15
18
⑦or ⑧
Recommended mounting hole Panel size
K==>all 55"
K==>8~18 65"
K==>15~18 70"
K==>18 75"
The specific installation holes can be adjusted
according to the actual needs, refer to the
installation height of the intelligent panel.
figure 4
3
Step3: Install the Wall Mount C on the lifting column B (figure 3).
C
②
②
figure 3

4
6
Step6: When using the Electric Stand, the control pad and the AC power
cable should be connected to the Electric Stand, and connected to the
power supply (figure 6).
F
figure 6
G
5
Step5: Hang the Interactive Flat Panel to the Electric Stand by Wall Mount,
and tighten the screws (figure 5).
③
figure 5

5
8
Step8: Done, as shown in figure 8.
figure 8
7
Step7: Plugging the AC Power transfe Cable and the USB
Cable in, user can interact with the Interactive Flat Panel (figure 7).
H
I
figure 7