Brateck LED-01X User manual

INSTALLATION I NSTRUCTI ONS
CAUTION: Do NoT ExcEED MAXIMUM
LISTED WEIGHT CAPACITY SERIOUS
INJURY OR PROPERTY DAMAGE MAY
occu R!
ISSUED: OCr.2O12

A wenNtNG
. Do not begin the installation until you have read and understood the instructions
and warnings contained in this installation sheet. lf you have any questions
regardinganyof theinstructionorwarning,pleasecontactyourlocal distributor.
. This mounting bracket was designed to be installed and utilized ONLY as
specified in this manual. lmproper installation of this product may cause damage
or serious rnjury.
. This product should only be installed by someone of good mechanical ability,
with basic building experiences and fully understanding of this manual.
. Make sure that the supporting surface will safely support the combined load of
the equipment and all attached hardware and components.
. lf mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. Use of a stud finder is highly recommended
. Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.
. Tighten screws firmly, but do not over tighten. Over tightening can damage the
items, greatly reducing their holding power
. This product intended for indoor use only Using this product outdoors could
lead to product failure and personal injury

IMPORTANT: Ensure thatyou have recerved alr partsaccordino tolnr
any parts are missins ", r",rr; ;15;;";;;J; ;U;,ji"ffiI:ffii :Jr::::";:llr to insrailins rr
su 1)
[46x14 (x4)
clamp(x2)
Ecable tie(x1 )
F
Itt/8x20 (x4)
M-C
wrench (xl )
M
[45x14 (x4)
concrete archor (x2)
DD
small spacer (x8) bjg spacer (x4)
D6 washer (x2)
w-c
/;t
v
washe(x4)
M-F
D5
Package M
ST6-3x50 (x2)
,>2

w@wwffi 1wr
'ilqIl4
,ft \
Find and mark the
exact location of
mounting holes
6-T_---__-)
l"l6a*l
lYl
Drill pilot holes
@@t@
Table I a.'l
The letter "a" stands for the wood stud interval, The letter "L"(see step 2) stands for the actual length of wirerope
I
,|
-r\a
vl56\. 406mm(16") 450mm(17.7") 600mm(23.6")
2UUx200mm
and below
400x400mm 700mm 710mm
600x600mm 750mm 750mm 880mm
800x800mm 880mm 880mm 900mm

WWZW
Table'1b.1
The letter "X" stands for the distance between wall plate
of wirerope
Mark the
exact location of
mounting holes
W-C
@@d
kll*lr*l
tJJtJC-ll-jCJ
The letter "L" (see step 2)stands for the actual length
Drill pilot holes
VESA 200x200mm
and below 400x400mm 600x600mm 800x800mm
X80-100mm 180-22Omm 380-420mm 580-620mm
L400mm 500mm 750mm 900mm

XF€
\ -.,

+