
combi shave = Combination shave (InterFace trimmer worksin tandem
with the shaver foil to first cut the longer problem hairs,
which then allowsthe foil to shave the shorter hairseven
closer) (b).
trimmer = The long hair trimmer isactivated (for trimming sideburns,
moustache and beard) (c).
3.2 Shaving with the cord
If the batteriesare discharged, you may also shave with the shaver connected
to the mains(100–240 V ~). (If the shaver should not run immediately, charge
it with the switch position «off» for approx. 1 minute.)
4 Keeping your shaver in top shape
4.1 Cleaning
• After shaving, switch the shaver off. Press the release buttons, take off the
shaver foil (d) and gently tap it out on a flat surface (e).
• Then thoroughly clean the cutter block with the brush (f). About every four
weeks, clean the cutter block with Braun cleaning agents(g).
• Do not clean the shaver foil with the brush.
• If you have a very dry skin and you notice a reduced operation time of the
shaver, you should put a drop of light machine oil onto the InterFace trimmer
and shaver foil (g).
4.2 Replacing the shaving parts
• To maintain 100% shaving performance, replace your foil and cutter block
every 18 monthsor when worn. Change both partsat the same time for a
closer shave with less skin irritation.
(Shaver foil and cutter block: part no. 3000)
• Press the release buttons, take off the shaver foil. Replace the new shaver foil
in the right direction until it locksin place.
• To remove the cutter block, lift it off (g).
• To replace the cutter block, snap onto the holding studs.
Tips for the perfect shave
• We recommend that you shave before washing, asthe skin tendsto be
slightly swollen after washing.
• Hold the shaver at right angles(90°) to the skin.
•Stretch your skin and shave against the direction of beard growth.
• To maintain 100% shaving performance, replace your foil and cutter block
every 18 monthsor when worn.
5634358_IF3775_Korea Seite 8 Freitag, 1. Dezember 2006 11:49 11