Braun EXACT6-memory uni Quick guide

Braun exact 6
memory universal
Type 5281
Beard trimmer
English
Use Instructions
Guarantee
Service Centers

2 3
English
Our products are engineered to meet
the highest standards of quality,
functionalityanddesign.Wehopeyou
thoroughly enjoy your new Braun
appliance.
Braun exact 6 memory universal
This appliance can be operated on all
international alternating current
outlets. Its built-in rechargeable cell
permits 2-way beard trimming: either
with the cord connected directly to an
outlet (cord operation) or without the
cord via the rechargeable cell
(cordless operation).
Specifications
Voltage range: 100-240 V (~)
50-60 Hz
Wattage: 3.5 W
Trimming system: cutting unit
3 ,
trimming width 34 mm,
distancing comb
4 for 6 beard length
settings (2, 5, 8,11,14,18 mm)
Memory function
Charging time: 2 hours
Quick charge for one trim: 10 minutes
Operating time: approx. 60 minutes
(fully charged)
The best environmental temperature
range for the trimmer is between
15°C - 35°C. The trimmer should
never be exposed to temperatures of
lessthan0°Cand more than 40 °C for
longer than a few hours.
Do not wind the cord around the
appliance.
Environmentally friendly cell unit
For environmenfal reasons, this
appliance is provided with a nickel-
hydrid cell unit. This cell unit does not
contain any poisonous heavy metals.
Nevertheless, in the interest of
recycling raw materials please
do not dispose of this appli-
ance in the household waste at
the end of its useful life.
Disposal can take place at a Braun
Service Centre or at appropriate
collection sites.
Description
1 Pilot light
2 Switch (on/off), cutting lenght)
3 Cutting unit
4 Distancing comb
5 Memory-Switch
6 Cleaning brush
Cord operation
The trimmer is ready for use
immediately via cord operation (i.e.
when the trimmer is connected
directly to an electrical outlet).
lfthe trimmershould,however,notrun
immediately due to a completely
empty cell, recharge the trimmer for
approx. 1 minute (switch turned off =
«0»), which is sufficient to permit
trimming via cord operation (after
turning the switch on again).
Cordless operation
Turn the trimmer off (switch
2 set to
«0»), connect the cord to the trimmer
and plug into an electrical outlet.
Rechargefor5 hours.Thepilotlight
1
is illuminated at the beginning of the
charging process and changes to
flashing as the appliance is being
charged, with increasingly longer
pauses. When recharged, unplug the
trimmer. The trimmer should not stay
connected to an outlet for several
weeks. Occasional overcharging for
several days will, however, not
damage the trimmer.

4 5
In order to maintain the full capacity of
the cell unit, it should be fully charged
(5 hours) before the first use and then
discharged by normal use until the
trimmer runs distinctly slower.
Then recharge for 2 hours. This
charging/discharging process should
berepeated about every 6 months. All
subsequent recharging also takes 2
hours.
Fully charged, the appliance gives
about 60 minutes of shaving.
Beard trimming
Place the distancing comb
4 on the
beard trimmer while the switch
2 is
turned off (= «0») and select the
desired beard length.
Thelength can easily be selected with
one hand (a). There are six length
settings (2, 5, 8,11,14,18 mm); setting
«6» is the longest beard length,
setting «1» the shortest.
It is advisable to start with setting «6»
and then reduce the setting until you
reach the desired beard length. Hold
the distancing comb with the angled
edge against your beard (b). The
distancingcombkeeps thecuttingunit
at right angles while it combs through
your beard. When giving your beard a
more thorough trimming or when
thinning out your beard, it is recom-
mended to guide the trimmer against
the direction of beard growth.
Memory function
Your beard trimmer is provided with a
memory function (switch
5 ), to
prevent you cutting your beard too
short by using the wrong setting.
When you have found the right cut-
ting length, you can simply move the
memory switch
5 to the right setting
(1-6) (a). The motor will not start
before the switch
2 has reached this
setting. For longer settings, you can
move switch
2 above the setting of
the memory switch
5 and the motor
will keep running.
Thememoryfunctionisretained,even
if the distancing comb
4 is removed
and put on again.
Note: The distancing comb
4 can
only be put on or taken off if the
trimmer is turned off (switch set to
«0»). When using for longer
applications, clean the distancing
comb with the brush
6 in between to
avoid clogging it with hair (d).
The cutting unit
3 is for trimming
hairlines, shaving off single hairs, or
shaping beards (c). For these
applications, the trimmer is used
without the distancing comb, and the
same setting as the memory function.
Cleaning and maintenance
Aftereveryuse,take off the distancing
comb
4 and clean with the cleaning
brush
6 .Tilt and liftoff the cutting unit
3 (e). Clean the appliance and the
cutting unit with the cleaning brush
(f, g). Press the cutting unit back on
the appliance until it snaps in place.
Occasionally, take off the cutting unit
3 and oil sparingly (h).
Important
Buy only original Braun spare parts,
especially when replacing the cord.
Only this way you can be assured of a
safe, close and efficient trim.
Subject to change without notice.
This product conforms to the
EMC-Requirements as laid
down by the Council Directive
89/336/EEC.
Guarantee
We grant a 1 year guarantee on the
product commencing on the date of
purchase.
Within the guarantee period we will
eliminate, free of charge, any defects
inthe applianceresultingfromfaultsin
material or workmanship either by
repairing, or exchanging parts or
exchanging the whole appliance as
we may choose.
Not covered by this guarantee:
damage arising from improper use,
normalwear anddefectswhichhavea
negligible effect on the value or
operation of the appliance.
The guarantee becomes void if
repairs are undertaken by
unauthorized persons and if original
Braun parts are not used.
Theguaranteeonlycomes into force if
the date of purchase is confirmed by
the dealer's stamp and signature on
the guarantee card and registration
card.
This guarantee extends to every
country where this appliance is
supplied by Braun or its appointed
distributor and where no import
restrictions or other legal regulations
hinder or prevent service being given
under guarantee.
Service under the guarantee does not
affect the expiry date of the guaran-
tee. The guarantee on parts or entire
appliances which are exchanged
ends when the guarantee on this
appliance expires.
In the event of a claim under this
guarantee, hand in the complete
appliance with the valid guarantee
card to your dealer, or send both to
the nearest Braun Customer Service
Centre.
Allother claims including fordamages
resulting from this guarantee are
excluded unless our liability is legally
mandatory.
Those claims arising out of the sales
contract with the vendor are not
affected by this guarantee.
For UK only:
This guarantee in no way affects your
rights under statutory law.