Braun Infusomat Space User manual

See Operator’s Manual for complete directions for use.
Rx only. ©2008 B. Braun Medical Inc. All rights reserved. IS64 12/09 JH
bbraunusa.com
1. Press .
2. Press .
3. Enter volume of bolus.
4. Press .
5. Time to deliver bolus is displayed.
6. Press “bolus” key.
7. Pump will give bolus and bolus will be
displayed on the screen
Pump will beep at completion of bolus.
GIVING BOLUS WITH DOSE
CALCULATION IN DRUG LIBRARY
1. Press Bolus key.
2. Hit OK for duration of bolus desired, up
to 10 seconds.
GIVING A MANUAL BOLUS
NOTE: Follow same three steps, but it will ask
for bolus limit vs. bolus dose.
BOLUS WITH VOLUME PRE-SELECTION
1. Press .
2. Press and set bolus limit by using
buttons.
3. Press to conrm and start bolus.
Note: When bolus is nished a warning
“beep” will sound.
1. Press button to access main menu.
2. Use to select Rate, Volume, Time, etc.
3. Press left arrow button.
4. Enter new rate/dose with keypad.
5. Conrm with .
6. Note: Adjust rate or dose while infusing
by pushing .
CHANGE RATE, VOLUME AND
TIME WHILE INFUSING
1. Press .
2. Adjust the rate or dose, as needed.
3. Conrm with .
TITRATE WHILE INFUSING
Use key to choose preferred criteria on left
hand corner of display -
ie: long drug name or volume tot (shift totals).
Depending upon therapy, dierent options
can be selected by scrolling using the key.
The choice shown on screen will remain until
is pressed for new selection.
SHORTCUTS
Infusomat® SPACE
Infusion Pump System
Quick
Reference

TO OPEN AND LATCH DOOR
1. Open door .
2. Load set from right to left.
3. Press 2-hole clip over the 2 pins on the
right of the pumping section.
4. Hold 2-hole clip down, align white clip
to the left over ridge in center.
5. Insure the green lever is fully pushed
down and the yellow light is on.
6. Press green ow clamp into green
chamber on far left until green lever
marked PRESS releases out. Point on
clip faces towards you and points down.
Note: Yellow light turns o.
7. Thread tubing into the left and right
notches to secure; close door.
8. Press to acknowledge Original
Space Line and begin.
NOTE: When trying to “power o”, pump
will automatically go to “Standby Mode” for
1-24 hours.
1. Turn POWER on.
2. Press to open door.
3. After set is loaded, hold sides of pump;
use both thumbs to press door rmly
closed.
4. Door will engage and nish closing.
TO END INFUSION
1. Press button to stop infusion. Green
LED will go o. Disconnect from patient
line.
2. Press . Conrm with .
Note: Expect some resistance from the
door, and continue to pull down door.
LOADING THE SET (POWER must be ON)
1. Stop the infusion by pressing .
2. Use up/down arrow keys to scroll
to “Special Functions”
3. Use to enter Special Functions.
4. Use up or down arrows to select
Piggyback. Press to select.
5. Select automatic or manual switch
over to Primary. Use to select, then
press .
6. Select option to use Drug Library for
Piggyback. Use or to answer Yes
or No to Drug Library. If Yes, select Care
Area and select drug.
7. Enter VTBI and rate if prompted.
8. When done, press . The word PIGGY
appears in display when infusing.
PIGGYBACK FUNCTION
1. Press while pump is running to get
Main Menu.
2. Select “Status” in Main Menu with
and press .
3. Highlight “Volume”in ml. Press
after highlighting and pump will
prompt to reset data.
4. Press to reset shift totals.
RESET DATA IN STATUS MENU
(Shift Totals)
For Clinical and Technical
Support, call 800-854-6851
TO START INFUSION
1. Choose New Patient by pressing .
2. If prompted for Drug Library, press .
Scroll to Care area and select by
pressing .
Scroll drug names by pressing or .
Scroll drug names alphabetically by
pressing or .
3. Enter volume to be infused and rate. If
prompted, enter patient weight.
4. Press to start infusion.
3. Open pump door. Remove tubing and
close front door.
4. Press for 3 seconds to switch pump
o.