Braven FLYE SPORT User manual

2
USER GUIDE
BRAVEN FLYE SPORT OVERVIEW
BRAVEN_FLYE-Sport-Earbuds_English-French_MANUAL_v11.indd 1 11/21/16 5:29 PM

Full manual and troubleshooting: braven.com/manuals
2
ENGLISH
BRAVEN FLYE SPORT OVERVIEW
INTERCHANGEABLE
EARBUD TIP
INLINE CONTROLS /
MICROPHONE
RECHARGEABLE
LITHIUM-ION BATTERY
TANGLE-FREE CABLE
BRAVEN_FLYE-Sport-Earbuds_English-French_MANUAL_v11.indd 2 11/21/16 5:29 PM

Full manual and troubleshooting: braven.com/manuals
3
ENGLISH 4
BRAVEN FLYE SPORT REMOTE
Power earbuds on by holding the Power button for three seconds
and power earbuds off by holding the Power button for ve seconds.
To Pair: Turn on earbuds and continue holding the Power button
to enter pairing mode (LED indicator on battery will flash red).
Select the earbuds from the available devices in your Bluetooth®
settings to complete pairing.
To Charge: Plug the included USB to Micro-USB cable into a wall
power adapter (not included). Insert the Micro-USB end of the
cable into the FLYE Micro-USB port. Users should fully charge
their earbuds before initial use. Audio cues notify you when battery
is less than or equal to 10%.
VOLUME UP /
SKIP FORWARD
(PRESS AND HOLD)
POWER ON / OFF,
PAIR, PLAY / PAUSE,
ANSWER / END CALL
MICRO USB PORT FOR CHARGING
VOLUME DOWN /
SKIP BACKWARD
(PRESS AND HOLD)
MICROPHONE
To reduce the risk of re or electric shock, do not expose
the Braven Earbuds to rain or moisture while charging.
The Braven Earbuds should not be exposed to dripping
or splashing, and objects lled with liquids, such as vases,
should not be placed on or near it while being charged or
charging other devices. As with any electronic products,
use care not to spill liquids into any part of the product.
Liquids can cause a failure and/or a re hazard. The power
supply must be used indoors only. Make no modications
to the product or accessories. Unauthorized alterations may
compromise safety, regulatory compliance, and system
performance, and will void the warranty. Do not place any
ame sources, such as lighted candles, on or near the
BRAVEN Earbuds. The BRAVEN Earbuds contains small
parts that may be a choking hazard and is not suitable for
children under age 3. Do not continue charging the battery
if it does not reach full charge within the specied charging
time. Overcharging may cause the battery to become hot,
rupture, or ignite. If you see any heat deformation or leakage,
properly dispose of the battery. Do not attempt to charge
the battery in temperatures outside the range of 32°-104°F
(0°-40°C). If the battery begins to leak, do not allow the liquid
to come in contact with your skin or eyes. If contact has been
made, wash the aected area with plenty of water and seek
medical attention immediately. Do not expose the product or
battery to excessive heat, including direct sunlight or re and
storage or use inside cars in hot weather, where it can be
exposed to temperatures in excess of 115°F (60°C). Doing
so may cause the battery and power supply to generate
heat, rupture, or ignite. Using the product in this manner
also may result in a loss of performance and a shortened
life expectancy. Extended exposure to direct sunlight may
damage the external appearance and material qualities. Do
not step on, throw, or drop batteries or the power supply or
device, or expose them to a strong shock. Do not pierce,
crush, dent, or deform the batteries or power supply in any
way. If either becomes deformed, properly dispose of it. Do
not short-circuit batteries. Do not attempt to service the
BRAVEN Earbuds yourself. Opening or removing covers may
expose you to dangerous voltages or other hazards and will
void the manufacturer’s warranty. To prevent risk of re or
electric shock, avoid overloading wall outlets, extension cords,
BRAVEN_FLYE-Sport-Earbuds_English-French_MANUAL_v11.indd 3 11/21/16 5:29 PM

Full manual and troubleshooting: braven.com/manuals
3
4
ENGLISH
BRAVEN FLYE SPORT REMOTE
Power earbuds on by holding the Power button for three seconds
and power earbuds off by holding the Power button for ve seconds.
To Pair: Turn on earbuds and continue holding the Power button
to enter pairing mode (LED indicator on battery will flash red).
Select the earbuds from the available devices in your Bluetooth®
settings to complete pairing.
To Charge: Plug the included USB to Micro-USB cable into a wall
power adapter (not included). Insert the Micro-USB end of the
cable into the FLYE Micro-USB port. Users should fully charge
their earbuds before initial use. Audio cues notify you when battery
is less than or equal to 10%.
WARNINGS, CAUTION &
LEGAL INFORMATION
To reduce the risk of re or electric shock, do not expose
the Braven Earbuds to rain or moisture while charging.
The Braven Earbuds should not be exposed to dripping
or splashing, and objects lled with liquids, such as vases,
should not be placed on or near it while being charged or
charging other devices. As with any electronic products,
use care not to spill liquids into any part of the product.
Liquids can cause a failure and/or a re hazard. The power
supply must be used indoors only. Make no modications
to the product or accessories. Unauthorized alterations may
compromise safety, regulatory compliance, and system
performance, and will void the warranty. Do not place any
ame sources, such as lighted candles, on or near the
BRAVEN Earbuds. The BRAVEN Earbuds contains small
parts that may be a choking hazard and is not suitable for
children under age 3. Do not continue charging the battery
if it does not reach full charge within the specied charging
time. Overcharging may cause the battery to become hot,
rupture, or ignite. If you see any heat deformation or leakage,
properly dispose of the battery. Do not attempt to charge
the battery in temperatures outside the range of 32°-104°F
(0°-40°C). If the battery begins to leak, do not allow the liquid
to come in contact with your skin or eyes. If contact has been
made, wash the aected area with plenty of water and seek
medical attention immediately. Do not expose the product or
battery to excessive heat, including direct sunlight or re and
storage or use inside cars in hot weather, where it can be
exposed to temperatures in excess of 115°F (60°C). Doing
so may cause the battery and power supply to generate
heat, rupture, or ignite. Using the product in this manner
also may result in a loss of performance and a shortened
life expectancy. Extended exposure to direct sunlight may
damage the external appearance and material qualities. Do
not step on, throw, or drop batteries or the power supply or
device, or expose them to a strong shock. Do not pierce,
crush, dent, or deform the batteries or power supply in any
way. If either becomes deformed, properly dispose of it. Do
not short-circuit batteries. Do not attempt to service the
BRAVEN Earbuds yourself. Opening or removing covers may
expose you to dangerous voltages or other hazards and will
void the manufacturer’s warranty. To prevent risk of re or
electric shock, avoid overloading wall outlets, extension cords,
or integral convenience receptacles. Your Bluetooth device
(mobile phone, music player, tablet, laptop, etc.) must support
the A2DP Bluetooth prole in order to work wirelessly with
your new BRAVEN Earbuds. The A2DP prole is supported by
most recent mobile products with built-in Bluetooth capability.
Please refer to your device’s user manual for details and
instruction regarding the Bluetooth proles it supports.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:—Reorient or relocate the receiving antenna. —
Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected. — Consult the
dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT: This device
complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions:
BRAVEN_FLYE-Sport-Earbuds_English-French_MANUAL_v11.indd 4 11/21/16 5:29 PM

Full manual and troubleshooting: braven.com/manuals
5
ENGLISH
WARNINGS, CAUTION &
LEGAL INFORMATION
or integral convenience receptacles. Your Bluetooth device
(mobile phone, music player, tablet, laptop, etc.) must support
the A2DP Bluetooth prole in order to work wirelessly with
your new BRAVEN Earbuds. The A2DP prole is supported by
most recent mobile products with built-in Bluetooth capability.
Please refer to your device’s user manual for details and
instruction regarding the Bluetooth proles it supports.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:—Reorient or relocate the receiving antenna. —
Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected. — Consult the
dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT: This device
complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions:
WARNINGS, CAUTION &
LEGAL INFORMATION (CONTINUED)
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter
may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Lithium Battery installed is not intended to be replaced by
the USER.
CAUTION: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
Where the MAINS plug is used as the disconnect device, the
disconnect device shall remain readily operable.
The device meets the exemption from the routine evaluation
limits in section 2.5 of RSS 102 Issue 5 and compliance
with RSS-102 RF exposure, users can obtain Canadian
information on RF exposure and compliance.
Correct Disposal of this product. This marking indicates
that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable
reuse of material resources. To return your used device,
please use the return and collection systems or contact the
retailer where the product was purchased.
This product complies with
California Energy Commission
eciency standards for consumer
battery chargers.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including
interference that may cause undesired operation of the device
BATTERY SAFETY: Store the portable backup battery in
a cool, dry place, and avoid exposure to moisture, high
temperatures, open ames, chemicals, or corrosive materials.
Do not short circuit, open, disassemble, modify, repair, or
replace any part of the portable backup battery. Doing so
may cause the battery to ignite, explode, leak, or become
excessively hot, causing personal injury. Avoid excessive
impact, physical shock, or vibration as they may damage the
portable backup battery. Inspect the case carefully before
each use, especially after any drop, bump or other impact,
to identify any sign of damage. If the portable backup battery
becomes damaged, swells, leaks, overheats, or functions
abnormally, immediately discontinue use and contact Incipio.
Avoid all contact with contents from a leaking battery. The
portable backup battery is designed to be charged many
times. Use the included micro USB cable and an approved
battery charger. Never use a modied or damaged battery
charger. Do not reverse charge or reverse connect the battery.
Please note the battery will normally be warm during charging.
Recycle or dispose of the portable backup battery’s batteries
properly and in accordance with applicable federal, state
and local laws and regulations. Do not dispose of batteries
in the trash or re.
BRAVEN_FLYE-Sport-Earbuds_English-French_MANUAL_v11.indd 5 11/21/16 5:29 PM