9
in the kettle ask (1);
- after heating the water to 70°C you will hear a sound
signal, the indicator of the button (13) « » will go out,
the digital symbols of the water temperature (14) will go
out after 30 seconds.
• The modes of water heating to the temperature of 80°C
and 90°C and 100°C work similarly.
• You can set the desired water heating temperature by
pressing one of the buttons (11) « , »:
- if the kettle is in the standby mode, press the kettle
on/o button (17) « », and the indicators of all control
buttons will light up;
- press the water heating mode button (10) « », press
the button (11) « » once, you will hear a sound signal,
the digital symbols (14) will indicate the water heating
temperature «40», the indicators of control buttons (11)
«, », (17) « » will be glowing, digital symbols (14)
will also show the temperature of water heating in the
kettle ask (1);
- after heating the water to 40°C you will hear a sound
signal, the indicators of the buttons (11) « , » will go
out, the digital symbols of the water temperature (14) will
go out after 30 seconds.
• A single press of the key (11) « » increases the water
heating temperature by 5 degrees, a single press of the key
(11) « » lowers the water heating temperature by 5 degrees.
• If you want to turn o the water heating mode, press the
On/O button (17) « ».
AUTOMATIC SWITCHING OFF OF THE KETTLE
• If you accidentally switched the kettle on, but the water
level appeared to be below the minimal mark, the
automatic thermal switch will be on and the kettle will
switch o. In this case take the kettle from the base (7)
and let it cool down for 10-15 minutes, then ll the kettle
with water and switch it on, the electric kettle will operate
in normal mode.
CLEANING AND MAINTENANCE
• Before cleaning disconnect the kettle from the mains,
pour out water and let the kettle cool down.
• Wipe the base (4) and the outer surface of the ask (5)
with a slightly damp cloth, and then wipe the base (4) and
the ask (5) dry. Use soft detergents to remove dirt; do not
use metal sponges and abrasive detergents and solvents.
• Do not immerse the kettle, the kettle stand (7), power cord
and power cord plug in water or any other liquid, do not
wash the kettle in the dishwasher.
DESCALING
• Scale, appearing inside the ask (1), inuences the water
taste and disturbs the heat exchange between water and
the heating element and also creates a risk of failure of
the heating element, the burnout of the heating element
because of large amount of scale in the ask (1) is not
covered by warranty.
• To remove scale, you can use special scale-removing
agents, as well as household ones, for example, vinegar
or citric acid.
