Breamer CTB-20845 User manual

(TH3/BM3)(English)
Manual Digital Thermostat - Heating
HOME OWNER’S MANUAL

2TH3/BM3
THIS APPLIANCE MUST BE INSTALLED AND SERVICED BY AUTHORISED
PERSONNEL ONLY.
DO NOT: Operate this appliance before reading these instructions.
DO NOT: Place articles on or against this appliance.
DO NOT: Use or store flammable materials near this appliance or its flue terminal.
DO NOT: Spray aerosols in the vicinity of this appliance or its flue terminal while it
is operating.
DO NOT: Operate this appliance with any parts removed.
DO NOT: Modify this appliance.
DO NOT: Fit filters to warm air outlet registers.
For 3 and 4 star heaters, it is recommended that a flue guard be fitted where
children may be able to touch the flue terminal - flue guard part No 079073.
HEATER IDENTIFICATION AND INSTALLATION
IMPORTANT SAFETY INFORMATION
IF YOUR HEATER STOPS WORKING
________________________
________________________
________________________
________________________
________________________
This
information
is to be
completed
by the
installer
Model No:
Serial No:
Installation date:
Installer:
Installer phone No:
Before requesting a service call please run through the simple checks in the
"Troubleshooting" section of this manual.
If required, call Braemar Service on 1300 650 644.
For spare parts call 1300 367 437.
Seeley International Pty Ltd has a policy of continuous product development and therefore reserves the right to make
changes to these specifications without notice. Whilst every care has been taken to ensure accuracy of the data compiled
in the document, Seeley International Pty Ltd does not assume any liability for errors and/or omissions.
Braemar is a registered trademark of Braemar Industries Pty Ltd.
Seeley International Pty Ltd ACN 054 687 035
Albury Manufacturing
77 North Street, Albury, NSW 2640

Heating mode
Temperature display
Heater On
Low Battery
Thermostat off
C
OFF
Display
ON/OFF
Backlight
Temperature
adjustment
HEATER OPERATION
SEELEY INTERNATIONAL – HOME OWNER’S MANUAL 3
Turning Heater On
1 Press ON/OFF button.
2 The heater and room fan will start
after a short delay (approximately
30-60 s) provided set temperature is
greater than room temperature.
Turning Heater Off
1 Press ON/OFF button.
2 Heater will turn off, room fan will stop
after approximately 60-90 s.
Adjusting Set Temperature
1 Press UP or DOWN ARROW button
to increase or decrease setting - the
displayed temperature will change to
set temparature and flash.
2 Each press will increase or decrease
the setting by 1oC.
Button Functions

TROUBLESHOOTING
House is Not Heating Effectively
1 Check thermostat is set to required
temperature - increase if required.
2 Check outlets are open to all areas
that require heating.
3 Check that return air grille is not
obstructed.
4Check that return air filter (where
fitted) is clean - cleaning every 2
weeks is recommended.
5 Check that external doors and
windows are closed.
Warranty Service
Australia 1-300-650-644
seeleyinternational.com
641133a seeleyinternational.com.au
It is the policy of Seeley International to introduce continual
product improvement. Accordingly, specifications are
subject to change without notice. Please consult with your
dealer to confirm the specifications of the model selected.
Heater Does Not Start
1 Check thermostat is set above room
temperature.
2 Reset the heater - turn thermostat
OFF-ON-OFF-ON with a 5 second
wait at each step.
3 Check that gas is turned on at gas
meter. If gas is turned off contact
your installer or gas supplier.
REPLACING THE BATTERIES
1When the battery symbol
appears new batteries are required.
2Un-clip the bottom of the front of the
thermostat and pull forwards.
3Fit 2 x AA batteries and clip front of
thermostat back in place (note
direction of battery ‘+’ and ‘-’).