BTR BT1030B SOLAR User manual

Troubleshooting:
If the solar light does not work at dusk after a full day charge, please try the following steps:
1. Make sure the solar panel is not being affected by any other light source.
The built-in sensor will activate the light only when the surrounding is dark.
2. Make sure the solar light is not positioned in the shade during the day.
3. Make sure the switch is in “ON” mode.
4. Check the batteries are correctly installed and in good condition.
Better lighting contact information:
World Wide head office:
Betterlighting Germany GmbH
Verkaufsbüro: Hansaring 7
63843 Niedernberg
Germany
Tel.: [phone]
Fax: [phone]
E-mail: [email protected]
North America head office:
Betterlighting USA, Inc.
1811 NE 146th ST
North Miami - FL 33181
USA
Tel: [phone]
Fax: [phone]
E-mail: [email protected]
Asia Pacific head office:
Betterlighting Australia Pty Ltd
Unit8/133-139 Beauchamp Road
Matraville, Sydney
New South Wales 2036
Australia
Tel: [phone]
Fax: [phone]
E-mail: [email protected] www.betterlighting.de
BETTERLIGHTING GERMANY GmbH
SOLAR HOUSE NUMBER

Turn the ON/OFF switch to “ON” mode, make sure the solar light is placed in a position where
sunlight will reflect on the solar panel free from cover and shade (for both Option 1 and 2).
Care and Maintenance:
Clean the solar module regularly with a damp towel to guarantee optimum performance of the
solar panel. Do not use any type of solvent for cleaning and be careful not to put too much
pressure on the module while cleaning.
Please note that the built-in rechargeable batteries need to be replaced after several years
(depending on the climate conditions of your area). To do the replacement, please follow the
image above.
Option 1
Step 3: Remove the assembly plate from the main
body. The assembly plate is not necessary
for this installing option.
Step 4: Drill two holes on the wall, insert the two
plastic expansion tubes into the holes and
fit the screws into the tubes. The two
screws should stick out evenly from the
wall. Then hang the House Number Light
onto the protruding screws.
Option 2
Step 3: Screw the two poles onto the assembly
plate as shown in Image A, and place it into
the ground as shown is Image B.
User manual for BTR Solar light
Please read this manual carefully before using your product for the first time.
Should you find the light diffuser broken, it is probably caused by occasional damages
during transportation, please contact the seller/distributor for replacement.
Please keep this manual in good condition, as you might need it for the battery
replacement in future.
Specification:
Solar panel: 2 V, 50 mA
2 LEDs X 0.06W
1 Built batteries: 600mAh 1.2V, AA
Suitable Places: Outdoor yard or Outdoor wall mounted places
Assembly and Placement:
Step 1: Carefully remove all the parts from the box.
Step 2: Select the desired numbers/letters and stick them on the exterior surface of the
glass. To ensure a straight number/letter layout, it is recommended to use the
provided stencil guide.