Butterfly Easifold Deluxe22 User manual

Easifold Deluxe22 Rollaway
Table Tennis Table
Assembly Instructions
Easif l DX2oll way
o d 2 R a
Easifold DX22 ollaway
R

PARTS LIST
P23
Esif ld D 22 Rolla ay
ao X w
s l yEa ifold DX22 Ro lawa
P3
P19
P7
P9
P25
P27
P10
P8
P6
P21
P2
P1
P26
P4
P5
P11
P14
P13
P12
P15
P16
P17
P18
P20
P22
P24
P25
P31
1. TABLE TOP LAMINATED BOARD- 1525×1370×22MM - 2 NOS.
2. END FRAME PIPE -1523×25×40MM - 2 NOS.
3. SIDE FRAME PIPE - 1310×25×40MM - 4 NOS.
4. INNER FRAME PIPE - 930×25×40MM - 2 NOS.
5. SMALL INNER FRAME PIPE - 150×25×40MM - 4 NOS.
6. OUTER LEG - 940×710×55×38MM - 2 NOS.
7. INNER LEG -1080×500×55×38MM - 2 NOS.
8. LONG BRACE SUPPORT - 665×25×7MM - 4 NOS.
9. WHEELASSEMBLY- 500×230×55×38MM - 4NOS.
10. SET OF 8 WHEELS - 75 MM WITH 2 LOCK WHEELS
11. BRACKETS FOR OUTER/INNER LEG - 75×28MM - 16 NOS.
2
12. BRACKETS FOR FRAME PIPE - 38MM - 20 NOS.
13. BRACKETS FOR SIDE LOCK - 75×19MM - 4NOS.
14. BOLTS FOR OUTER/INNER LEG 62×7.5MM - 8 NOS.
15. BOLTS FOR LONG BRACE SUPPORT FIXED TO OUTER/INNER LEG
- 75×7.5 - 6 NOS.
16. BOLTS FOR SIDE LOCK ATTACHED TO OUTER LEG - 88×6MM
WITH NUT WASHERAND BHOGLI - 2NOS.
17. BOLTS FOR SIDE LOCK ATTACHED TO BRACKET - 31×6MM - 2 NOS.
18. DOME NUT - 10MM- 8 NOS.
19. OUTER CORNER - 53MM - 4 NOS.
20. SET OF POST CORNER - 50×18MM - 2 NOS.
21. LEVELLERS - 55×38MM CAPSULE - 4 NOS.
22. CENTRE LOCK - 2 NOS.
23. SIDE LOCK - 2 NOS.
24. L CORNER TOATTACH P3 & P5 - 23×17MM - 4 NOS.
25. PLASTIC CAPS FOR INNER FRAME PIPE - 25×40MM - 8 NOS.
26. WHEEL ASSEMBLY CAP - 45×25MM - 8 NOS.
27. NET POST SET - 1 NOS.
28. BOLTS TOATTACHED WHEELASSEMBLY( P9) WITH INNER LEG (P7)
75×7.5MM - 8 NOS.
29. SPARE NET - 1 NOS.
30. SCREW FOR BRACKETS ON TOP 8/32- 48 NOS. 8/13- 216NOS.
31. SCREW FOR OUTER CORNER & POST CORNERS - 6/13- 20 NOS.
32. SPANNER - 7.5/6MM - 2 NOS.

ADULT ASSEMBLY REQUIRED
P-27 - 75×7.5MM - QTY. - 8
P-5 - 7.5/6 MM - QTY. - 2 P-9 - 500×230×55×38 MM - QTY. - 4
PLEASE READ THE SAFETYINSTRUCTIONSATTHE BOTTOM OF PAGE- 4
STEP- 2 SLIGHTLY PULL OUT
THE OUTER LEGS (P6)
& PUSH OPEN THE
TABLE SLIGHTLY BY
OPENING CENTRE
LOCK (P22).
P-27 - 7.5MM - QTY. - 8
STEP - 1
CAREFULLY LIFT THE TABLE TOP HALF TOATTACH WHEEL ASSEMBLY (P9)
WITH INNER LEG (P7) USING NUT & BOLT 75×7.5AND TIGHTEN IT WITH
THE HELP OF TWO SPANNERS

STORING THE TABLE
STEP- 1
PULL OUT THE SIDE LOCK (P23) TO LIFT THE TABLE ON THE WHEELS.
MAKE SURE THAT LOCK (P22) IS LOCKED PROPERLY FOR STORAGE
REPEAT THE SAME FOR THE 2ND HALF.
STEP- 2
STEP- 5 STEP- 6
YOUR TABLE IS NOW READY FOR PLAY
Safety Instructions: Children below 14 years should not assemble the table. When lowering each half of the table top, make sure
that the outer legs P6 are pulled gently outwards from the underside of the table, so far as they can go. Failure to do this may result
in injury or damage to the table. This table is suitable for indoor use. It can be used outdoors provided that it is not exposed to direct
sunlight rain or frost. It should always be stored indoors. Make sure that the wheel brakes are off when moving the table and are on
when the table is stored or in the play position.
STEP- 3
STEP- 4
REPEAT THE SAME FOR THE 2ND HALF OF THE TABLEAS IN STEP- 1, 2 & 3
ADJUST THE HEIGHT REQUIRED WITH THE HELP OF LEVELLERS (P21)ATTACHED ON
ALL 4 OUTER LEGS (P6).
NOW SLIGHTLY PULL OUT THE
SIDE LOCK (P23) & SLOWLY
BRING DOWN THE TABLE
STEP- 7