How to use
1. If the button on the bottom is in upper level, it is
wired mouse, plug in the cable with mouse and
computer, it works.
2. Swith on the button on bottom to the lower level, 2.4G
wireless mode.
3. Press the left , scroll wheel and right button at
the same time until LED flash, plug in the nano receiver,
when the led off, mouse connected.
4. Switch the Scroll whell and forward button at the
same time to switch the LED, there is 9 kinds of LED in
total.
5. Place the button on the bottom in middle level, it
is 2.4G wireless mode,but power saving, in this situation,
only LOGO and scroll wheel LED light on.
6. When it is low battery, scroll wheel and LOGO LED
flash red for 3 seconds and breathing for warning.
7. When it is charging, scroll wheel and Bytezone LOGO
LED keep green for 10s, and back to original LED.
