Cable-Tronix CT-DTA-TOSLINK User manual

v1.0 12/5/11
1
INSTALLATION MANUAL
CT-DTA-TOSLINK
Digital to Analog Audio Converter

v1.0 12/5/11
2

v1.0 12/5/11
3
PACKAGE CONTENTS
This package contains:
One CT-DTA-TOSLINK digital to analog converter
One 5VDC @2A power supply
One CT-DTA-TOSLINK Installation Manual
PRODUCT DESCRIPTION
The CT-DTA-TOSLINK is a digital to analog audio converter designed for residential and
professional audio switching. The unit converts Coaxial or Toslink digital audio signals to analog
Left/Right audio via connection to an external device such as an amplifier via RCA jacks. The CT-
DTA-TOSLINK supports 32, 44.1, 48 and 96KHz sampling rates; 24-bit S/PDIF incoming bit
stream on left and right channels; electromagnetic, noise-free transmission and is easy to install
and operate.
SPECIFICATIONS
CT-DTA-TOSLINK
Specifications (Typical)
1. Input Audio
Coaxial or Toslink digital audio
2. Output Audio
Left/Right analog audio
3. Input Audio Connector
Toslink, 1 RCA (coaxial)
4. Output Audio Connector
2 RCA (left and right)
5. Sampling Rate
32, 44.1, 48 and 96KHz
6. Power Requirement
5VDC @2A external power supply
7. Power Consumption
0.5 watts (maximum)
8. Operating Temperature
32°F ~ 158°F
9. Operating Humidity
10% ~ 85%relative humidity (no condensation)
10. Dimensions
2.0”x1.6”x1”
11. Weight
2.75 oz

v1.0 12/5/11
4
INSTALLATION
1. UNPACKING and HANDLING
Each unit is shipped assembled and factory tested. Ensure that all accessories are removed
from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or Cabletronix at 1-610-429-1511 for
assistance.
3. PRODUCT DIAGRAM
4. HARDWARE CONNECTIONS
a. Connect the digital audio source to the Input side of the unit. If a Toslink connection
use the Toslink port. If a coaxial connection use the coaxial port.
b. Connect the unit’s Output side to the analog audio equipment using the RCA Right
and Left connectors.
c. Connect the included 5VDC@2A power supply to the unit’s power connector. Insert
the power supply into an available AC outlet.
Troubleshooting assistance can be found on-line at www.cabletronix.com in addition to
support from Cabletronix sales engineers at 1-610-429-1511.