- 2 -
FEATURES
• Bedside or tabletop alarm clock with LED lamp
• Displays time, date and indoor temperature
• 12- or 24-hour time format
• Temperature in °F or °C
• Five built-in digital Soothing Sounds
• Programmable sleep timer (10-60 minutes)
• Digital alarm clock with snooze function
• 7 alarm sound choices
• Wake to light + sound
• Programmable Snooze interval (1-60 minutes)
• Lamp features 30 non-stroboscopic, energy-
saving LEDs to create a soothing light that's easy
on the eyes
• Long lasting LEDs have 100,000-hour lifetime
• Dimmable lamp can be used for reading or
nightlight
• Optional Voice Control Mode (Night Mode): Clock
display is automatically dimmed until it hears your
voice or a loud noise such as clapping or a finger
snap.
• Optional battery backup (2 AAA batteries required)
• Plugs into an AC outlet
POWER SET UP
1. Insert 2 AAA alkaline batteries (not included) into
the backup battery compartment. The display will
run through a brief initialization process, then beep
once before flashing the default time, date and
temperature.
2. Plug the device into an AC outlet.
TURNING ON THE LAMP
• Tap any part of the aluminum strip. The lamp will
illuminate and rise.
• While the lamp is ON, touch and hold any part of
the aluminum strip. The lamp will DECREASE in
brightness.
• Touch and hold the aluminum strip again, and the
lamp will INCREASE in brightness.
• Tap any part of the aluminum strip. The lamp will
turn OFF and descend to its original position.
LISTENING TO SOOTHING SOUNDS
• Press the Sound button once to turn the
Soothing Sounds ON. Press again to turn the
Soothing Sounds OFF.
• Press the Sound button again to turn ON the
NEXT Soothing Sound.
• Repeat pressing the Sound button to cycle
through all five Soothing Sounds:
1. Chirping crickets + croaking frogs
2. Wave sounds + chirping birds
3. Wave sounds + gull sounds
4. A group of chirping birds
5. A quacking duck + a babbling brook
NOTE: The Sleep Timer turns OFF the Soothing
Sounds automatically after a specific number
of minutes. Press the TIMER button (“T”) to
choose 10, 20, 30, 40, 50 or 60-minute play time.
After setting the Sleep Timer, you will see the
remaining time count down on the display. The
normal Time / Date / Temperature display will
resume in 15-20 seconds.
SETTING THE DATE AND TIME
To set the Date and Time, you will need to
program the following information in this order:
YEAR >> MONTH >> DATE >> HOUR >> MINUTE.
NOTE: Once the Date and Time are set, you may
select 12- or 24-hour time format by pressing
the UP button.
1. Press the SET button (“S”). The YEAR will flash.
Use the UP and DOWN buttons to set the YEAR.
Press the SET button again to confirm the YEAR
and move on to the next setting (MONTH).
