Assembly Instructions
The installation must conform with local codes or, in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Storage and Handling of
Liquefied Petroleum Gases, ANSI/NFPA 58; or Natural Gas and Propane
Installation Code, CSA B149.1; Propane Storage and Handling, CSA B149.2, or
the Standard for Recreational Vehicles, ANSI A119.2/NFPA 1192; and
Recreational Vehicle Code, CSA Z240 RV Series, as applicable.
This appliance must be installed on the opposite side, from the fuel
distribution/dispensing system of RV.
The insallation of the appliance must preclude the possibility of operation or gas
flow when in storage (travel) position.
This appliance must be connected to the vehicles propane system with a flexible
hose connector complying with the high pressure requirements of the Standard for
Pigtails and Hose Connections for LP-Gas, ANSI/UL 569, and must be of the
length no longer than that required to allow the grill to be mounted in the “in Use”
position of its mounting system.
The hose must be installed in a manner that will not allow it to come in contact
with the hot surface of the grill while in use or in the storage/travel mode.
WARNING
Do not use this appliance under extended awnings. Failure to comply could result
in a fire or personal injury.
DANGER
Do not put grill in storage or travel mode immediately after use. Allow grill to cool
to touch before moving or storing. Failure to do so could result in fire resulting in
property damage, personal injury, or death.
5
www.camplux.com
Visit Us: Camplux.com
8350 Patriot Blvd STE B, North Charleston, SC 29420 1(844) 538-7475
