Canary Products HZ119BL User manual

Blue World HUMIDIFIER
Instruction Manual
Model: HZ119BL

2
OPERATING INSTRUCTIONS
IMPORTANT SAFEGUARDS
READ AND SAVE THESE INSTRUCTIONS
In order to avoid electric shock, fire and/or serious personal injury,
when using electrical appliances, basic safety precautions should
always be followed, including the following:
1. READ ALL INSTRUCTIONS
2. Check that the voltage power corresponds to that stated on the
appliance.
3. To protect against electrical shock do not immerse cord, plugs,
power base or the appliance in water or other liquid.
4. Close supervision is necessary when any appliance is used near
children. This product is not a toy and should be used out of
reach of children. This product shall not be used by children,
without close supervision.
5. Unplug from outlet when not in use and before cleaning.
6. Do NOT operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any
manner. Return appliance to the nearest authorized service
facility for examination, repair, or adjustment.
7. The use of accessory attachments not recommended by the
appliance manufacturer may cause injuries.
8. Do NOT use outdoors.
9. Do NOT let cord hang over edge of table or counter, or touch
hot surfaces.
10. Do NOT place on or near a hot gas or electric burner, or in a
heated oven.
11. Always attach plug to appliance first, then plug cord into the wall
outlet. To disconnect, put the switch in off position, then remove
plug from wall outlet.
12. Do NOT use appliance for other than intended use.
13. When removing mineral deposit, only use products specially
formulated for the removal of mineral deposit. Never use

3
ammonia or any other substance that might be dangerous to
your health.
14. Do NOT refill with water while the appliance is switched on.
15. Use on a water resistant, hard, flat level surface only.
16. NEVER use the appliance if it has been dropped on the floor or
damaged in any way.
17. Always have water in the water tank when operating the unit.
18. Please USE TAP OR MINERAL WATER ONLY. To avoid, calcium build
up, please clean with vinegar and hot water once every four
uses.
19. Be sure that the filling cap of the tank is firmly tightened.
20. Always have the mist direction nozzle and the mist chamber in
place while the unit is operating. Rotate the appliance so that
the mist nozzle aims away from children, walls and furniture.
21. Do not add medication of any type into the nozzle, base or water
tank. Do not cover any openings on the unit or insert objects into
any openings.
22. The unit should not be left unattended in closed rooms as the air
could become saturated and leave condensation on walls or
furniture. Always leave the room door partly open.
23. When cleaning the inside of the unit, keep water away from the
air outlet. The exterior may be wiped with a damp cloth, except
the electrical controls, when the unit is off. (Any part may be
wiped with a damp cloth when the unit is unplugged.)
24. Do not tilt or tip the unit or attempt to empty or fill it while it is in
operation.
25. If using detergent to clean any parts of the unit that contains
water use detergent sparsely and rinse abundantly. Detergent
deposit dissolved in the water supply might else interfere with the
output of the unit.
HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS

4
SHORT CORD INSTRUCTIONS
A short detachable power supply cord is provided to reduce the
hazards resulting from becoming entangled in, or tripping over a
longer cord. Longer detachable power supply cords may be used if
care is exercised in their use.
The electrical rating of the longer cord should be at least that
of the appliance. If the electrical rating of the extension cord
is too low, it could overheat and burn.
The longer cord should be arranged so that it will not drape
over the counter top or tabletop where it can be pulled on by
children or tripped over.
SPECIFICATIONS
Capacity:
HZ119 : 2.5L
Noise level : less than 35 dB
Rated voltage: 110V, 60Hz.
DESCRIPTION
An ultrasonic Cold Mist humidifier nebulizes water into mist, using the
principle of ultrasonic high frequency oscillation, and diffuses the
cool mist uniformly into the air by means of a pneumatic device.

5
PARTS DESCRIPTION
1. Nebulizer (in Main housing)
2. Water level float (in Main housing)
3. Air Inlet (in Main housing)
4. Cap with water valve (on Tank)
5. Mist outlet channel (in Tank)
6. Mist output nozzle
7. Water tank
8. Power/No Water LED light(s)
9. Mist output adjustment
10. Main housing
11.
2
1
3
2
4
5
6
7
9
10
8

6
BEFORE THE FIRST OPERATION
Before using your humidifier, please make sure that you position the
appliance on a flat and hard surface, which is water-resistant. Avoid
using on any porous or delicate surface that could be damaged by
water. Do not use on an unstable surface, from which the humidifier
could tilt and drop.
Using is a well-ventilated place helps for a good repartition of the
humidification.
OPERATION
Separate the water tank and central body, turn over the tank
and remove the cap from the bottom of the tank, turning it
counterclockwise
Fill the tank with cold water; do not fill completely.
Replace the cap, aligning the notches on the tank with the
grooves on the cap, and turn it clockwise.
Turn the tank over, and place it on the main body, making sure it
fits perfectly.
Plug in and turn on the appliance using the power switch; the
green pilot light in the humidifier housing lights on. After a few
seconds, vapor will start to spray out from the spray nozzle.
Use the mist intensity control to adjust the quantity of mist output.
Turning the knob clockwise will increase the moisture output.
NOTE: it is NOT recommended to use the mist output at a
maximum level at first, as this might spray too much mist and a
pool of water might form near the appliance. Please start with a
medium setting and adjust later to the desired mist output.
The humidifier has a safety system that switches the appliance off
before it runs completely out of water, due to the water level
float. When the water will be almost depleted, the red LED will
light on. This safety feature is made to protect the nebulizer from
being damaged due to lack of water.
To resume operation, simply switch off, refill the water tank with
fresh water and place the tank back on the main housing. Switch
back on to start humidifier’s function.

7
CLEANING AND MAINTENANCE
Before any cleaning operation, switch the appliance off and unplug
it.
Always unplug the unit before cleaning.
Apart from the electrical controls and when the unit is off, any
part of the humidifier may be wiped with a soft damp cloth and
buffed with a dry cloth, ensuring the unit is unplugged.
There may be some mineral deposits in the nebulizer, particularly
if the water in your area is hard. This deposit will influence the
humidification process and decrease performance gradually.
HENCE, IT IS HIGHLY RECOMMENDED TO USE PURIFIED WATER.
Please clean the nebulizer with water and vinegar on a soft cloth
regularly, as follows:
1. Dampen a cloth with vinegar and wipe the nebulizer gently,
until the mineral deposit disappears.
2. Rub down with a dry cloth and remove remains of humidity.
2. Do NOT rub the nebulizer with hard or abrasive objects.
4. Do NOT clean with chemical products.
Clean the inside of the water tank at least once a week, as
follows:
1. Fill the tank with clean water adding a few drops of bleach or
a similar disinfectant, or mild cleaning detergent (not much or
else it will be more difficult to rinse). Close the tank completely
with its cap and shake forcibly.
2. Rinse thoroughly.
Note: Water accumulated over long periods may create bacteria
and mildew (fungus).
With each change of water the use is recommended to remove
dust and any lime remains on the nebulizer (preferably use a
small soft brush, like a toothbrush).
Do not place the nebulizer directly under the tap to avoid
permanent damage.
Never immerse the unit in water or let water enter the air outlet or
any other openings.
Water must not get inside the base part; should that happen,
take it to an authorized service center before using it again.

8
STORAGE
Save the box for off-season storage.
Always drain and clean before storage.
Make sure the tank, reservoir and all parts are thoroughly dry
before storage.
If water is left in the unit during storage, it may harden and leave
deposits that can prevent the unit from operating properly later.
Leave the cap of the water tank loose or apart, during storage,
to prevent the tank and the gasket from sticking together. This will
prolong the life of the gasket.
A NOTE ABOUT HUMIDITY
It is best to keep the humidity level at about 30-50 percent of
relative humidity.
The comfort level of humidity will vary from room to room and
with changing room conditions.
In cold weather, especially in unventilated areas, windows and
even some walls may fog or develop frost from excessive indoor
humidity. If this occurs, reduce the mist intensity setting to avoid
damage from condensed water dripping on windows or walls.
Too much humidity in the room may allow moisture to
accumulate on surfaces where bacteria and fungi can grow.
Moisture that gathers may also damage furniture and walls,
especially wallpaper.
To eliminate excessive humidity, especially in small rooms, leave
the room door open and adjust the mist intensity control setting.

9
TROUBLESHOOTING
Symptoms
Possible reason
Solution
Power light off, no
blowing, no mist
Power is disconnected
or no power
Connect to power
supply
Main switch off- or
knob at the lowest
level
Turn on the appliance
using the switch and
turn the knob to the
right
Power light on, air blowing,
no mist
No water in tank or
using distilled water
Add water into the
water tank and switch
to tap water
Cover of water level
protection switch not
closed properly
Reinstall the water
tank to fit perfectly in
place.
Power light on, no
blowing, no mist
Water level too high in
the water basin.
Remove some of the
water in the tank; put
the tank back in
place.
Power light on, no
blowing, no mist
Water level float (in
Main housing) is
stuck (no. 2 in
diagram)
Simply move the
water level floater a
few times up and
down with a pen to fix
this issue. Leave it on
when you are doing
this and it should mist
right away.
Power light on, no
blowing, no mist
The knob is set at the
low level.
Foul smell of mist
New machine
Keep the water tank
uncovered and open
in a cool place for 12
hours
Dirty water or water
stored for too long
Clean the water tank,
replace the water
Small mist output
Mist level set too low
Increase the mist
output level
Mineral deposit on
transducer
Clean the transducer
(see above)
Dirty water or water
Replace with clear

10
stored too long
water
Abnormal noise
Resonance caused by
insufficient water in
tank
Add clean water in
the tank
Resonance with
surface where the unit
is placed
Place on another flat,
stable surface or on
the ground
Mist spilled from around
the nozzle
Gaps between nozzle
and water tank
Soak nozzle in water
before use
Water pooling on the
countertop
Too much mist
produced
Decrease the mist
output
Air saturated with
water
Keep room ventilated,
with door opened
Water in the tank does not
flow down
Hole in the cap of the
tank is blocked
Clear the blocked
hole/valve.
ATTENTION!
If you face any issues or problems with our products, please let us help you first
before returning the product. We will resolve your issue as quickly as possible and
we will respond within 4 hours.
Email: [e-mail]
We prefer you email us, as we can resolve your issues better that way. However, if
you need a quicker answer please call us at 888-980-3119 ext. 1.