Canon PIXMA MX360 Series Instruction and safety manual

Dedicated Fax Line
Setup Guide
MX360 or MX410
Next

Connecting The Phone Lines
NextPrevious

Connecting The Phone Lines
Next
Previous 3
Before
Wall jack
After
(Phone Cord included with Canon printer)
Wall jack

If Your Wall Plate Has Two Jacks
Use the jack that supports the fax line.
NextPrevious 4

If Your Wall Plate Has One Jack For Two Lines
If your wall jack provides one jack for two phone lines, it would be best to use a
“2 Line 3 Way Adapter.” This adapter can be purchased at most stores that sell
electronics. This device creates three plugs where there was one. One jack will
be for your voice line. The other jack can be used for your fax transactions. In
most cases, line 1 (L1) is used for phone calls; L2 is used of faxing. The third
jack (L1+L2) allows access to both lines. This is where you would plug in a 2-
line telephone, if available.
The L1 jack is usually your
voice line The L2 jack is usually your fax line
NextPrevious 5

Fax to Phone Line Connection
First, connect one end of the supplied telephone cord to the telephone jack on
the wall.
NextPrevious 6
(Phone Cord included with Canon printer)
Wall Jack

Fax to Phone Line Connection
Next, connect the other end of the supplied telephone cord to the lower jack
(labeled “L”) on the MX360 or MX410.
NextPrevious 7
(Phone Cord included with Canon printer)
Wall Jack

Setting Up The Receive Mode
NextPrevious

Step 1
Turn on the MX360 or MX410 by
pressing the ON button.
Step 2
Press the FAX button.
NextPrevious 9
MX360 MX410

Step 4
Use the Left or Right Arrow button to
select “Receive mode set”.
Step 3
Press the Menu button
NextPrevious 10