Car Solutions NAVI5CH User manual

LVDS to RGB Signal Converter for QVI
Installation Guide
car-solutions.com
car-solutions.com

•NAVI5CH-TO RGB Product Components
NAVI5CH-TORGB-V2.0SET
COMPONENTS EA
QCPASS1351 : TEST : NAVI5CH-TORGB-V2.0 1
HPOWER0227 : NAVI5CH TO RGB POWER CABLE 1
HRGBCA0024 : RGB UART CABLE 1
TOTAL 3
1
car-solutions.com
car-solutions.com

•NAVI5CH-TO RGB power cable pin map
2
car-solutions.com
car-solutions.com

•NAVI5CH-TO RGB RGB UART cable pin map
3
car-solutions.com
car-solutions.com

•Installation Diagram with QROIX
4
car-solutions.com
car-solutions.com

•Installation Diagram with Carplay box
Power (Acc, GND)
OR
5
RGB Cable tagged
HRGCA0024
car-solutions.com
car-solutions.com

RGB Cable tagged
HRGCA0024
Carplay 4Pin Touch
port
Supplied 4Pin Touch
between PCM3.1
interface and Carplay
HTOUCH0049
LVDS TO RGB Sub
board 6
•Installation Diagram with Carplay box
car-solutions.com
car-solutions.com

RGB Cable tagged
HRGCA0024
UART
Connection
Carplay 4Pin Touch
port
4Pin Touch between
CDR31 and Carplay
7
•Installation Diagram with Carplay box
car-solutions.com
car-solutions.com

① Please find the Pin No.4
tagged PB12 of Power cable on
the interface.
③ Please remove the yellow
pin from RGB cable tagged
HRGCA0024
② Please wire it with another
one. *Please make sure that
the opposite side of the wire
has the terminal to plug to the
connector of RGB Cable.
④ Please insert the wire to the
empty pin of the RGB cable
which yellow pin is removed.
⑤ Please connect the RGB
cable to the Converter.
•In case uart_tx wire in interface power connector
8
car-solutions.com
car-solutions.com

Please make sure that the yellow pin
of No.7 should be placed to the last
on RGB cable.
(This wire is for Uart touch. If it is
wrongly placed, touch will not work.)
•In case uart_tx wire in interface rgb-in connector
9
car-solutions.com
car-solutions.com

① Please find Uart wire on the
board above. And pin map is as
below.
① RX ② TX ③ No use
Please use TX wire for use of
touch.
④ Please insert the wire to the empty pin of
the RGB cable which yellow pin is removed.
⑤ Please connect the RGB cable
to the Converter.
①②③
② Please wire it with
another one. *Please make
sure that the opposite side
of the wire has the terminal
to plug to the connector of
RGB Cable.
③ Please remove the yellow pin from
RGB cable tagged HRGCA0024
•In case uart_tx wire in interface ts_out connector
10
car-solutions.com
car-solutions.com

① Please find the Pin No.2 on
the rest port and please
connect one wire as same as
above picture.
② Please remove the
yellow pin No.6 from
RGB cable tagged
HRGCA0024
③ Please insert the wire from
test port to the empty pin of
the RGB cable which yellow
pin is removed.
④ Please connect the RGB
cable to the Converter.
*In case of using OEM MMI I Drive, Uart wire should be connected.
•In case uart_tx wire in interface debug_test connector
11
car-solutions.com
car-solutions.com